EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
Vi tager imod kryptovaluta — så den krypto, du ejer, kan købe rigtig hardware.Betal med krypto, brug det på rigtig hardware. Gratis, forsikret levering til hele verden ved køb over 399 $. Neutrale, umærkede papkasser, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Din kurs låses i 30 minutter, så snart kassen åbner.Kurs låst i 30 minutter. Hver vare er forseglet, har kontrolleret serienummer og er dækket af 24 måneders garanti.Forseglet, 24 måneders garanti.
Computer Memory Solutions
Dual-channel 4 GB DDR2-667 ECC kit validated for Intel S3200SH, S3210SH, SE7230CA1-E and SE7230NH1-E servers
This 4 GB kit contains two 2 GB DDR2 modules built for Intel S3200SH, S3210SH, SE7230CA1-E and SE7230NH1-E servers. ECC protection and unregistered operation match the platform requirements exactly. It is not for desktops, workstations or any system that needs registered DIMMs or a different DDR generation.
Each module runs at the standard 1.8 V DDR2 voltage with no heat spreader, so power draw stays low in normal server workloads. Passive cooling from chassis airflow is sufficient; no extra fan or active cooling is required. Noise remains at the level of the existing system fans.
The two sticks fill two of the four available slots and raise total memory toward the 8 GB platform maximum. ECC capability lets the server detect and correct single-bit errors, improving data integrity for always-on workloads. No software or drivers are included; the modules are ready to install and recognised by the system BIOS.
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM256725300ECCNRDR |
| Capacity | 4GB (2 x 2GB) |
| Type | 240-Pin DDR2 SDRAM |
| Speed | DDR2 667 (PC2 5300) |
| CAS Latency | CL5 |
| Timing | 5-5-5 |
| Voltage | 1.8V |
| ECC | Yes |
| Buffered/Registered | Unregistered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Intel S3200Sh, S3210Sh, Se7230Ca1-E, Se7230Nh1-E |
| Package Content | 2 Memory RAM Sticks |
Power down the server, open the chassis, align each module's notch with the slot key, and press firmly until both retention clips click; the step often missed is seating both modules in the correct channel pair so the board recognises the full 4 GB.
No routine maintenance is required; if a module fails the ECC logic will report corrected errors in the system log, at which point the faulty stick should be replaced with an identical 2 GB DDR2 667 CL5 1.8 V 2Rx8 DIMM.
The platform's maximum of 8 GB across four sockets is reached with two of these kits, so capacity is the first ceiling; bandwidth is capped at the DDR2 667 data rate and CL5 latency.
Også på denne hylde
Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.
Det du betaler med, og det du ser priserne i.
Sendes fra din tegnebog i kassen
Kun til visning — kataloget er prissat i USD
Ingen valuta matcher det.
Vælg det sprog, siden taler til dig på.
Ny her?
Har du allerede en?
Der findes ingen automatisk nulstilling: denne butik sender ingen e-mails, så der er intet engangslink at bede om. Efterlad adressen på kontoen, så bliver den behandlet manuelt.
Anmodning registreret
Der er intet på vej til din indbakke — denne butik sender slet ingen e-mails. Nogen behandler dem manuelt.
Kom du i tanke om den?