OWC 16GB DDR4 3200MHz CL22 1.2V 260pin SODIMM Alienware X17 R1
- 16GB
- 260-Pin DDR4 Non-EC…
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
Computer Memory Solutions
Dual-channel 4 GB DDR2-667 ECC kit validated for Intel S3200SH, S3210SH, SE7230CA1-E and SE7230NH1-E servers
This 4 GB kit contains two 2 GB DDR2 modules built for Intel S3200SH, S3210SH, SE7230CA1-E and SE7230NH1-E servers. ECC protection and unregistered operation match the platform requirements exactly. It is not for desktops, workstations or any system that needs registered DIMMs or a different DDR generation.
Each module runs at the standard 1.8 V DDR2 voltage with no heat spreader, so power draw stays low in normal server workloads. Passive cooling from chassis airflow is sufficient; no extra fan or active cooling is required. Noise remains at the level of the existing system fans.
The two sticks fill two of the four available slots and raise total memory toward the 8 GB platform maximum. ECC capability lets the server detect and correct single-bit errors, improving data integrity for always-on workloads. No software or drivers are included; the modules are ready to install and recognised by the system BIOS.
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM256725300ECCNRDR |
| Capacity | 4GB (2 x 2GB) |
| Type | 240-Pin DDR2 SDRAM |
| Speed | DDR2 667 (PC2 5300) |
| CAS Latency | CL5 |
| Timing | 5-5-5 |
| Voltage | 1.8V |
| ECC | Yes |
| Buffered/Registered | Unregistered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Intel S3200Sh, S3210Sh, Se7230Ca1-E, Se7230Nh1-E |
| Package Content | 2 Memory RAM Sticks |
Power down the server, open the chassis, align each module's notch with the slot key, and press firmly until both retention clips click; the step often missed is seating both modules in the correct channel pair so the board recognises the full 4 GB.
No routine maintenance is required; if a module fails the ECC logic will report corrected errors in the system log, at which point the faulty stick should be replaced with an identical 2 GB DDR2 667 CL5 1.8 V 2Rx8 DIMM.
The platform's maximum of 8 GB across four sockets is reached with two of these kits, so capacity is the first ceiling; bandwidth is capped at the DDR2 667 data rate and CL5 latency.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?