Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
Spool of grey 3D printer filament on a reel

E3D Online

E3D Online spoolWorks EDGE Filament 2.85mm 750g Cement Grey28 3D Printers Accessories

SKU CH-28A1-GPEN7

PETG-based filament combining ABS toughness with PLA ease for strong, low-warp prints

  • ColorGray
  • TypeFilament
  • Recyclable PETG-based material reduces environmental impact
  • Prints without unpleasant fumes or odours for comfortable use
  • Strong, tough filament with naturally glossy finish
  • Adheres to bed surfaces using only a little gluestick
  • Works with Scaffold support for clean breakaway and reliable adhesion

Filament diameter and weight

This E3D spoolWorks EDGE filament comes in a 2.85 mm diameter on a 750 g spool. It is a PETG-based material developed in-house for 3D printing. The Cement Grey28 colour provides a naturally glossy finish. The spool is supplied new and ready to use.

Makers wanting tough PETG with low warp

The filament suits users who need strong, resilient parts with minimal warping and excellent layer adhesion. It prints easily without unpleasant fumes and sticks to the bed with a little gluestick. Builders who require a different diameter or a non-PETG material should look at other options.

2.85 mm diameter

The critical specification is the 2.85 mm filament diameter, which must match the printer’s extruder and hot-end system. Using the wrong diameter will cause feeding failures and print defects. Verify this figure against your hardware before purchase.

Istaknuto

  • Recyclable PETG-based material reduces environmental impact
  • Prints without unpleasant fumes or odours for comfortable use
  • Strong, tough filament with naturally glossy finish
  • Adheres to bed surfaces using only a little gluestick
  • Works with Scaffold support for clean breakaway and reliable adhesion

Specifikacije

BrandE3D
ModelEdge
ColorGray
TypeFilament

Pitanja o ovom artiklu

How often will the 750 g spool need replacing during regular printing?

Replacement depends on print volume and part size; a 750 g spool yields many small models or fewer large ones before a new spool is required.

What limitation appears first during long, continuous prints with this Edge filament?

The spool will run out after the 750 g of material is consumed, which is the primary limit during extended sessions.

Does the filament produce noticeable fumes or heat when the printer runs all day?

The material prints with no unpleasant fumes or odors, and normal hot-end heat is the only thermal output during operation.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.