NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
Micro Connectors
A 5V 2.5A Micro USB power adapter with a built-in on/off switch, UL and FCC approved, DoE Level VI efficiency, and over-voltage and short-circuit protection for Raspberry Pi boards
This Micro Connectors 5V 2.5A Micro USB power adapter delivers a stable 12.5W output for Raspberry Pi boards and similar development devices. The integrated on/off switch lets you cycle power without unplugging the cable, reducing connector wear during frequent restarts. UL and FCC approvals plus over-voltage and short-circuit protection provide safe operation across 100-240V AC mains.
The adapter meets DoE Level VI efficiency standards, limiting no-load and active-mode waste heat during continuous use. A 47-inch cable allows flexible placement away from the power strip, keeping the brick clear of other equipment. With a weight of 0.25 lb the unit adds negligible load to a bench or enclosure mount.
Makers who have relied on generic phone chargers gain a dedicated 2.5A supply rated for the full load of a Raspberry Pi 3, Pi 2, Pi 1 or Pi Zero. The inline switch eliminates the need to pull the Micro USB plug for every reboot, preserving the board's power port. Builders needing higher current for Pi 4 or USB-C devices should select a different adapter.
| Brand | Micro Connectors |
|---|---|
| Model | RAS-PWR03-PI |
| Features | Specifications: Input: AC 100-240V / 50-60 Hz Output: DC 5V / 2.5A Cable length: 47 inches (3.9 feet) Weight: 0.25 lb. Features: UL and FCC Approved Convenient ON/OFF Switch DoE Level VI Efficiency Over Circuit Protection Short Circuit Protection Compatible with all Raspberry Pi Micro-USB connector |
| Težina pošiljke | 0.09 kg |
| Dimenzije pakiranja | 157 × 64 × 38 mm |
Plug the Micro USB connector into the Pi's power input, then use the inline on/off switch to control power instead of repeatedly unplugging the cable. The 47 inch cable provides enough length to position the adapter conveniently.
The built-in on/off switch is designed to handle daily power cycling so the Micro USB connector does not take mechanical stress. The 3.9 foot cable is fixed to the adapter and not user-replaceable.
The adapter delivers up to 2.5A at 5V (12.5W) continuously. Over voltage and short-circuit protection will activate if the connected draw exceeds the rated output or a fault occurs.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?