NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.
Micro Connectors
A 5V 2.5A Micro USB power adapter with a built-in on/off switch, UL and FCC approved, DoE Level VI efficiency, and over-voltage and short-circuit protection for Raspberry Pi boards
This Micro Connectors 5V 2.5A Micro USB power adapter delivers a stable 12.5W output for Raspberry Pi boards and similar development devices. The integrated on/off switch lets you cycle power without unplugging the cable, reducing connector wear during frequent restarts. UL and FCC approvals plus over-voltage and short-circuit protection provide safe operation across 100-240V AC mains.
The adapter meets DoE Level VI efficiency standards, limiting no-load and active-mode waste heat during continuous use. A 47-inch cable allows flexible placement away from the power strip, keeping the brick clear of other equipment. With a weight of 0.25 lb the unit adds negligible load to a bench or enclosure mount.
Makers who have relied on generic phone chargers gain a dedicated 2.5A supply rated for the full load of a Raspberry Pi 3, Pi 2, Pi 1 or Pi Zero. The inline switch eliminates the need to pull the Micro USB plug for every reboot, preserving the board's power port. Builders needing higher current for Pi 4 or USB-C devices should select a different adapter.
| Brand | Micro Connectors |
|---|---|
| Model | RAS-PWR03-PI |
| Features | Specifications: Input: AC 100-240V / 50-60 Hz Output: DC 5V / 2.5A Cable length: 47 inches (3.9 feet) Weight: 0.25 lb. Features: UL and FCC Approved Convenient ON/OFF Switch DoE Level VI Efficiency Over Circuit Protection Short Circuit Protection Compatible with all Raspberry Pi Micro-USB connector |
| Teža pošiljke | 0.09 kg |
| Velikost pošiljke | 157 × 64 × 38 mm |
Plug the Micro USB connector into the Pi's power input, then use the inline on/off switch to control power instead of repeatedly unplugging the cable. The 47 inch cable provides enough length to position the adapter conveniently.
The built-in on/off switch is designed to handle daily power cycling so the Micro USB connector does not take mechanical stress. The 3.9 foot cable is fixed to the adapter and not user-replaceable.
The adapter delivers up to 2.5A at 5V (12.5W) continuously. Over voltage and short-circuit protection will activate if the connected draw exceeds the rated output or a fault occurs.
Tudi v tem oddelku
Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.
V čem plačujete in v čem berete cene.
Poslano iz Vaše denarnice ob blagajni
Samo za prikaz — katalog je cenovno izražen v dolarjih
Nobena valuta ne ustreza.
Izberite jezik, v katerem Vam govori spletna stran.
Prvič tu?
Že imate račun?
Samodejne ponastavitve ni: ta trgovina ne pošilja e-pošte, zato ni enkratne povezave, ki bi jo lahko zahtevali. Pustite naslov na računu — nekdo ga bo obravnaval ročno.
Zahteva zabeležena
V Vašo elektronsko pošto ne prihaja nič — ta trgovina ne pošilja nobene e-pošte. Zahteve nekdo obravnava ročno.
Ste se spomnili?