OWC 16GB DDR4 2133MHz CL15 1.2V 288pin UDIMM 2U1D42R816GB
- 16GB
- 288-Pin DDR4 Non-EC…
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
OWC
16GB DDR4 SODIMM running at 2133MHz CL15 1.2V, validated for HP EliteOne 800 G2
This 16GB DDR4 SODIMM is built specifically for the HP EliteOne 800 G2 all-in-one. It uses a 260-pin form factor and operates at 2133MHz with CL15 latency. The module is unbuffered, non-ECC and runs at the standard 1.2V voltage. It suits owners who need a direct, compatible memory increase for this exact system.
Without a heat spreader, the module relies on the system's existing airflow and runs at the low JEDEC standard voltage of 1.2V. This keeps power draw minimal and produces no audible noise of its own. The 2Rx8 rank organisation is handled within the normal thermal envelope of the EliteOne 800 G2 chassis.
JEDEC compliance and OWC in-house validation mean the rated 2133MHz speed and CL15 timing hold under continuous workloads. The 16GB capacity allows larger datasets to remain in memory during extended multitasking sessions. Builders needing ECC error correction or registered signal buffering should select a different module type.
| Brand | OWC |
|---|---|
| Part Number | 2S1D42R816GB |
| Capacity | 16GB |
| Type | 260-Pin DDR4 Non-ECC SODIMM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.2V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | HP EliteOne 800 G2 |
Druge verzije ovog modela
Ista obitelj, različita memorija, hladnjak ili frekvencija — usporedite prije kupnje.
Power off and unplug the unit, open the memory access panel, align the notch on the module with the slot key, press firmly until the side clips click, then replace the panel before powering on.
No routine maintenance is required; the module is built to JEDEC and RoHS standards for long-term reliability and is covered by OWC's limited lifetime warranty.
The rated speed of 2133MHz and CL15 latency are the operating ceiling; sustained workloads will not push the module beyond these JEDEC specifications.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Nema odgovarajućeg jezika.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?