OWC 16GB DDR4 2133MHz CL15 1.2V 288pin UDIMM 2U1D42R816GB
- 16GB
- 288-Pin DDR4 Non-EC…
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
OWC
16GB DDR4 SODIMM running at 2133MHz CL15 1.2V, validated for HP EliteOne 800 G2
This 16GB DDR4 SODIMM is built specifically for the HP EliteOne 800 G2 all-in-one. It uses a 260-pin form factor and operates at 2133MHz with CL15 latency. The module is unbuffered, non-ECC and runs at the standard 1.2V voltage. It suits owners who need a direct, compatible memory increase for this exact system.
Without a heat spreader, the module relies on the system's existing airflow and runs at the low JEDEC standard voltage of 1.2V. This keeps power draw minimal and produces no audible noise of its own. The 2Rx8 rank organisation is handled within the normal thermal envelope of the EliteOne 800 G2 chassis.
JEDEC compliance and OWC in-house validation mean the rated 2133MHz speed and CL15 timing hold under continuous workloads. The 16GB capacity allows larger datasets to remain in memory during extended multitasking sessions. Builders needing ECC error correction or registered signal buffering should select a different module type.
| Brand | OWC |
|---|---|
| Part Number | 2S1D42R816GB |
| Capacity | 16GB |
| Type | 260-Pin DDR4 Non-ECC SODIMM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.2V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | HP EliteOne 800 G2 |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Power off and unplug the unit, open the memory access panel, align the notch on the module with the slot key, press firmly until the side clips click, then replace the panel before powering on.
No routine maintenance is required; the module is built to JEDEC and RoHS standards for long-term reliability and is covered by OWC's limited lifetime warranty.
The rated speed of 2133MHz and CL15 latency are the operating ceiling; sustained workloads will not push the module beyond these JEDEC specifications.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?