OWC 16GB DDR4 2133MHz CL15 1.2V 288pin UDIMM 2U1D42R816GB
- 16GB
- 288-Pin DDR4 Non-EC…
Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.
OWC
16GB DDR4 SODIMM running at 2133MHz CL15 1.2V, validated for HP EliteOne 800 G2
This 16GB DDR4 SODIMM is built specifically for the HP EliteOne 800 G2 all-in-one. It uses a 260-pin form factor and operates at 2133MHz with CL15 latency. The module is unbuffered, non-ECC and runs at the standard 1.2V voltage. It suits owners who need a direct, compatible memory increase for this exact system.
Without a heat spreader, the module relies on the system's existing airflow and runs at the low JEDEC standard voltage of 1.2V. This keeps power draw minimal and produces no audible noise of its own. The 2Rx8 rank organisation is handled within the normal thermal envelope of the EliteOne 800 G2 chassis.
JEDEC compliance and OWC in-house validation mean the rated 2133MHz speed and CL15 timing hold under continuous workloads. The 16GB capacity allows larger datasets to remain in memory during extended multitasking sessions. Builders needing ECC error correction or registered signal buffering should select a different module type.
| Brand | OWC |
|---|---|
| Part Number | 2S1D42R816GB |
| Capacity | 16GB |
| Type | 260-Pin DDR4 Non-ECC SODIMM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.2V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | HP EliteOne 800 G2 |
Ďalšie verzie tohto modelu
Rovnaký rad, iná pamäť, chladič alebo frekvencia — porovnajte pred rozhodnutím.
Power off and unplug the unit, open the memory access panel, align the notch on the module with the slot key, press firmly until the side clips click, then replace the panel before powering on.
No routine maintenance is required; the module is built to JEDEC and RoHS standards for long-term reliability and is covered by OWC's limited lifetime warranty.
The rated speed of 2133MHz and CL15 latency are the operating ceiling; sustained workloads will not push the module beyond these JEDEC specifications.
Aj v tomto oddelení
Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.
Mena, v ktorej platíte, a mena, v ktorej sa zobrazujú ceny.
Odoslané z vašej peňaženky na pokladni
Len na zobrazenie — katalóg je uvedený v dolároch
Žiadna mena nezodpovedá.
Vyberte jazyk, v ktorom s vami bude web komunikovať.
Žiadny jazyk nezodpovedá.
Ste tu prvýkrát?
Účet už máte?
Automatický reset hesla neexistuje: tento obchod neposiela žiadne e-maily, takže neexistuje jednorazový odkaz, o ktorý by ste mohli požiadať. Nechajte adresu na účte — niekto sa jej ujme ručne.
Žiadosť zaznamenaná
Do vašej schránky nič nepríde — tento obchod neposiela vôbec žiadne e-maily. Niekto sa o to postará ručne.
Spomenuli ste si?