OWC 16GB DDR4 2133MHz CL15 1.2V 288pin UDIMM 2U1D42R816GB
- 16GB
- 288-Pin DDR4 Non-EC…
Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.
OWC
16GB DDR4 SODIMM running at 2133MHz CL15 1.2V, validated for HP EliteOne 800 G2
This 16GB DDR4 SODIMM is built specifically for the HP EliteOne 800 G2 all-in-one. It uses a 260-pin form factor and operates at 2133MHz with CL15 latency. The module is unbuffered, non-ECC and runs at the standard 1.2V voltage. It suits owners who need a direct, compatible memory increase for this exact system.
Without a heat spreader, the module relies on the system's existing airflow and runs at the low JEDEC standard voltage of 1.2V. This keeps power draw minimal and produces no audible noise of its own. The 2Rx8 rank organisation is handled within the normal thermal envelope of the EliteOne 800 G2 chassis.
JEDEC compliance and OWC in-house validation mean the rated 2133MHz speed and CL15 timing hold under continuous workloads. The 16GB capacity allows larger datasets to remain in memory during extended multitasking sessions. Builders needing ECC error correction or registered signal buffering should select a different module type.
| Brand | OWC |
|---|---|
| Part Number | 2S1D42R816GB |
| Capacity | 16GB |
| Type | 260-Pin DDR4 Non-ECC SODIMM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.2V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | HP EliteOne 800 G2 |
Druge različice tega modela
Ista družina, različen pomnilnik, hladilnik ali takt — primerjajte, preden se odločite.
Power off and unplug the unit, open the memory access panel, align the notch on the module with the slot key, press firmly until the side clips click, then replace the panel before powering on.
No routine maintenance is required; the module is built to JEDEC and RoHS standards for long-term reliability and is covered by OWC's limited lifetime warranty.
The rated speed of 2133MHz and CL15 latency are the operating ceiling; sustained workloads will not push the module beyond these JEDEC specifications.
Tudi v tem oddelku
Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.
V čem plačujete in v čem berete cene.
Poslano iz Vaše denarnice ob blagajni
Samo za prikaz — katalog je cenovno izražen v dolarjih
Nobena valuta ne ustreza.
Izberite jezik, v katerem Vam govori spletna stran.
Ni ustreznega jezika.
Prvič tu?
Že imate račun?
Samodejne ponastavitve ni: ta trgovina ne pošilja e-pošte, zato ni enkratne povezave, ki bi jo lahko zahtevali. Pustite naslov na računu — nekdo ga bo obravnaval ročno.
Zahteva zabeležena
V Vašo elektronsko pošto ne prihaja nič — ta trgovina ne pošilja nobene e-pošte. Zahteve nekdo obravnava ročno.
Ste se spomnili?