NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
Replace Power
A 420W ATX replacement for Dell Dimension 4600 and 4700 desktops with SATA, 20+4 pin and peripheral connectors
This 420W ATX power supply is built specifically for Dell Dimension 4600 and 4700 desktops. It matches the original form factor and connector layout so the unit fits without modification. The grey enclosure houses a single 80mm fan for cooling. It suits owners restoring or upgrading those legacy systems.
The unit uses a standard ATX design with a manual 110V/220V input selector for global mains compatibility. A 20+4 pin motherboard connector supports both 20-pin and 24-pin boards. One 12V ATX connector, two large peripheral connectors, two short large connectors, one small connector and a single SATA lead cover internal devices. Cable lengths are 14-inch for motherboard and 12V leads and 15-inch for SATA and large peripheral leads.
All necessary power leads are permanently attached so there are no loose cables to route or misplace. The connector mix covers hard drives, optical drives and older floppy devices in one package. No software or driver installation is involved; the supply is purely a hardware swap. Buyers needing higher wattage for modern graphics cards or multiple drives should look elsewhere.
| Brand | Replace Power |
|---|---|
| Model | RPSU-C99-49 |
| Color | Grey |
| Type | ATX |
| Fans | 1 |
| Weight | 0.1 |
The unit includes a 20+4 pin ATX connector that fits both 20-pin and 24-pin motherboard sockets.
The SATA connector cable is 15 inches long and each ATX power connector cable is 14 inches long.
Remove the old PSU, fit this ATX unit into the same mounting points, connect the 20+4 pin, 12V ATX, SATA, Molex and floppy leads, then set the 110V/220V switch to match local mains voltage before powering on.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?