NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.
Replace Power
A 420W ATX replacement for Dell Dimension 4600 and 4700 desktops with SATA, 20+4 pin and peripheral connectors
This 420W ATX power supply is built specifically for Dell Dimension 4600 and 4700 desktops. It matches the original form factor and connector layout so the unit fits without modification. The grey enclosure houses a single 80mm fan for cooling. It suits owners restoring or upgrading those legacy systems.
The unit uses a standard ATX design with a manual 110V/220V input selector for global mains compatibility. A 20+4 pin motherboard connector supports both 20-pin and 24-pin boards. One 12V ATX connector, two large peripheral connectors, two short large connectors, one small connector and a single SATA lead cover internal devices. Cable lengths are 14-inch for motherboard and 12V leads and 15-inch for SATA and large peripheral leads.
All necessary power leads are permanently attached so there are no loose cables to route or misplace. The connector mix covers hard drives, optical drives and older floppy devices in one package. No software or driver installation is involved; the supply is purely a hardware swap. Buyers needing higher wattage for modern graphics cards or multiple drives should look elsewhere.
| Brand | Replace Power |
|---|---|
| Model | RPSU-C99-49 |
| Color | Grey |
| Type | ATX |
| Fans | 1 |
| Weight | 0.1 |
The unit includes a 20+4 pin ATX connector that fits both 20-pin and 24-pin motherboard sockets.
The SATA connector cable is 15 inches long and each ATX power connector cable is 14 inches long.
Remove the old PSU, fit this ATX unit into the same mounting points, connect the 20+4 pin, 12V ATX, SATA, Molex and floppy leads, then set the 110V/220V switch to match local mains voltage before powering on.
Aj v tomto oddelení
Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.
Mena, v ktorej platíte, a mena, v ktorej sa zobrazujú ceny.
Odoslané z vašej peňaženky na pokladni
Len na zobrazenie — katalóg je uvedený v dolároch
Žiadna mena nezodpovedá.
Vyberte jazyk, v ktorom s vami bude web komunikovať.
Ste tu prvýkrát?
Účet už máte?
Automatický reset hesla neexistuje: tento obchod neposiela žiadne e-maily, takže neexistuje jednorazový odkaz, o ktorý by ste mohli požiadať. Nechajte adresu na účte — niekto sa jej ujme ručne.
Žiadosť zaznamenaná
Do vašej schránky nič nepríde — tento obchod neposiela vôbec žiadne e-maily. Niekto sa o to postará ručne.
Spomenuli ste si?