NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.
Replace Power
A 420W ATX replacement for Dell Dimension 4600 and 4700 desktops with SATA, 20+4 pin and peripheral connectors
This 420W ATX power supply is built specifically for Dell Dimension 4600 and 4700 desktops. It matches the original form factor and connector layout so the unit fits without modification. The grey enclosure houses a single 80mm fan for cooling. It suits owners restoring or upgrading those legacy systems.
The unit uses a standard ATX design with a manual 110V/220V input selector for global mains compatibility. A 20+4 pin motherboard connector supports both 20-pin and 24-pin boards. One 12V ATX connector, two large peripheral connectors, two short large connectors, one small connector and a single SATA lead cover internal devices. Cable lengths are 14-inch for motherboard and 12V leads and 15-inch for SATA and large peripheral leads.
All necessary power leads are permanently attached so there are no loose cables to route or misplace. The connector mix covers hard drives, optical drives and older floppy devices in one package. No software or driver installation is involved; the supply is purely a hardware swap. Buyers needing higher wattage for modern graphics cards or multiple drives should look elsewhere.
| Brand | Replace Power |
|---|---|
| Model | RPSU-C99-49 |
| Color | Grey |
| Type | ATX |
| Fans | 1 |
| Weight | 0.1 |
The unit includes a 20+4 pin ATX connector that fits both 20-pin and 24-pin motherboard sockets.
The SATA connector cable is 15 inches long and each ATX power connector cable is 14 inches long.
Remove the old PSU, fit this ATX unit into the same mounting points, connect the 20+4 pin, 12V ATX, SATA, Molex and floppy leads, then set the 110V/220V switch to match local mains voltage before powering on.
Arī šajā sadaļā
Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.
Kriptovalūta, kurā maksājat, un valūta, kurā redzat cenas.
Nosūtīts no Jūsu maciņa, noformējot pasūtījumu
Tikai informatīvi — katalogā cenas norādītas ASV dolāros
Neviena valūta neatbilst.
Izvēlieties valodu, kurā vietne sarunājas ar Jums.
Pirmo reizi šeit?
Jau ir konts?
Automātiskas atiestatīšanas nav: šis veikals nesūta e-pastus, tāpēc nav arī vienreizējas saites, ko pieprasīt. Atstājiet adresi kontā, un tā tiks apstrādāta manuāli.
Pieprasījums saņemts
Uz Jūsu e-pastu nekas neatnāks — šis veikals vispār nesūta e-pastus. Kāds šos pieprasījumus apstrādā manuāli.
Atcerējāties?