NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
Replace Power
A 420W ATX replacement for Dell Dimension 4600 and 4700 desktops with SATA, 20+4 pin and peripheral connectors
This 420W ATX power supply is built specifically for Dell Dimension 4600 and 4700 desktops. It matches the original form factor and connector layout so the unit fits without modification. The grey enclosure houses a single 80mm fan for cooling. It suits owners restoring or upgrading those legacy systems.
The unit uses a standard ATX design with a manual 110V/220V input selector for global mains compatibility. A 20+4 pin motherboard connector supports both 20-pin and 24-pin boards. One 12V ATX connector, two large peripheral connectors, two short large connectors, one small connector and a single SATA lead cover internal devices. Cable lengths are 14-inch for motherboard and 12V leads and 15-inch for SATA and large peripheral leads.
All necessary power leads are permanently attached so there are no loose cables to route or misplace. The connector mix covers hard drives, optical drives and older floppy devices in one package. No software or driver installation is involved; the supply is purely a hardware swap. Buyers needing higher wattage for modern graphics cards or multiple drives should look elsewhere.
| Brand | Replace Power |
|---|---|
| Model | RPSU-C99-49 |
| Color | Grey |
| Type | ATX |
| Fans | 1 |
| Weight | 0.1 |
The unit includes a 20+4 pin ATX connector that fits both 20-pin and 24-pin motherboard sockets.
The SATA connector cable is 15 inches long and each ATX power connector cable is 14 inches long.
Remove the old PSU, fit this ATX unit into the same mounting points, connect the 20+4 pin, 12V ATX, SATA, Molex and floppy leads, then set the 110V/220V switch to match local mains voltage before powering on.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?