NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Akceptujemy kryptowaluty — posiadane środki można więc wykorzystać na zakup prawdziwego sprzętu.Płatność kryptowalutą — realny sprzęt w zamian. Bezpłatna, ubezpieczona dostawa na całym świecie powyżej 399 $. Neutralne kartony, bez oznaczeń, wysyłane z Niemiec.Bezpłatna, ubezpieczona dostawa powyżej 399 $. Kurs zostaje zablokowany na 30 minut od otwarcia kasy.Kurs zablokowany na 30 minut. Każdy produkt jest fabrycznie zapieczętowany, jego numer seryjny jest sprawdzany, a całość objęta jest 24-miesięczną gwarancją.Zapieczętowane fabrycznie, 24 miesiące gwarancji.
Replace Power
A 420W ATX replacement for Dell Dimension 4600 and 4700 desktops with SATA, 20+4 pin and peripheral connectors
This 420W ATX power supply is built specifically for Dell Dimension 4600 and 4700 desktops. It matches the original form factor and connector layout so the unit fits without modification. The grey enclosure houses a single 80mm fan for cooling. It suits owners restoring or upgrading those legacy systems.
The unit uses a standard ATX design with a manual 110V/220V input selector for global mains compatibility. A 20+4 pin motherboard connector supports both 20-pin and 24-pin boards. One 12V ATX connector, two large peripheral connectors, two short large connectors, one small connector and a single SATA lead cover internal devices. Cable lengths are 14-inch for motherboard and 12V leads and 15-inch for SATA and large peripheral leads.
All necessary power leads are permanently attached so there are no loose cables to route or misplace. The connector mix covers hard drives, optical drives and older floppy devices in one package. No software or driver installation is involved; the supply is purely a hardware swap. Buyers needing higher wattage for modern graphics cards or multiple drives should look elsewhere.
| Brand | Replace Power |
|---|---|
| Model | RPSU-C99-49 |
| Color | Grey |
| Type | ATX |
| Fans | 1 |
| Weight | 0.1 |
The unit includes a 20+4 pin ATX connector that fits both 20-pin and 24-pin motherboard sockets.
The SATA connector cable is 15 inches long and each ATX power connector cable is 14 inches long.
Remove the old PSU, fit this ATX unit into the same mounting points, connect the 20+4 pin, 12V ATX, SATA, Molex and floppy leads, then set the 110V/220V switch to match local mains voltage before powering on.
Także w tym dziale
Ten sam dział, ta sama kasa — osiem kryptowalut i 30-minutowa blokada kursu.
Waluta płatności i waluta wyświetlania cen.
Wysyłane z portfela przy kasie
Tylko podgląd — katalog wyceniony jest w dolarach
Brak pasującej waluty.
Wybierz język, w którym wyświetla się strona.
Pierwsza wizyta?
Konto już założone?
Nie ma automatycznego resetowania hasła: ten sklep nie wysyła żadnych e-maili, więc nie ma jednorazowego linku, o który można by poprosić. Adres pozostawiony przy koncie zostanie obsłużony ręcznie.
Zgłoszenie zapisane
Do skrzynki odbiorczej nic nie trafi — ten sklep nie wysyła żadnych e-maili. Zgłoszenia są obsługiwane ręcznie.
Hasło się przypomniało?