OWC 16GB DDR4 3200MHz CL22 1RX8 SODIMM laptop RAM
- 16GB
- 260-Pin DDR4 SO-DIMM
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
OWC
16 GB DDR4 ECC SODIMM at 2933 MHz with CL21 latency and 1.2 V for laptops and NAS systems
This 16GB DDR4 2933MHz CL21 ECC SODIMM targets laptops, all-in-one systems and NAS units that require error-correcting memory. The unbuffered 260-pin module operates at 1.2V and meets JEDEC specifications for reliable operation in compatible micro servers and POS equipment.
The module is backward compatible with 2666MHz, 2400MHz and 2133MHz slots, so it can replace older DDR4 sticks in supported platforms. The upgrade is worthwhile when the system accepts ECC unbuffered memory and the workload benefits from the higher 2933MHz data rate and single 16GB capacity.
In most cases the SODIMM installs without tools by opening the memory door and seating the 260-pin module until the clips lock. The usual pitfalls are attempting to use the stick in non-ECC consumer laptops, mixing it with registered DIMMs, or exceeding the platform's maximum supported memory per slot.
| Brand | OWC |
|---|---|
| Part Number | 2C9D41R816GB |
| Capacity | 16GB |
| Type | 260-Pin DDR4 SO-DIMM |
| Speed | DDR4 2933 (PC4 23400) |
| CAS Latency | CL21 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Heat Spreader | No |
| Recommend Use | Laptops, All-in-One Systems, and NAS Systems |
A modell további verziói
Ugyanaz a termékcsalád, eltérő memória, hűtés vagy órajel — hasonlítsa össze, mielőtt dönt.
This module uses the standard 260-pin DDR4 SO-DIMM form factor. It fits any laptop or all-in-one system that accepts DDR4 SO-DIMMs and is backward compatible with 2666MHz, 2400MHz and 2133MHz slots.
Align the notch on the module's gold edge with the key in the slot, insert at a slight angle, then press down firmly until both side clips click into place. The step many miss is pushing hard enough to engage both clips fully.
No ongoing maintenance is needed. The module has no heat spreader and runs at 1.2V. If a future platform requires non-ECC memory, the module would need to be replaced, but the memory itself does not degrade differently from standard DDR4.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Nincs egyező nyelv.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?