OWC 16GB DDR4 3200MHz CL22 1RX8 SODIMM laptop RAM
- 16GB
- 260-Pin DDR4 SO-DIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
OWC
16 GB DDR4 ECC SODIMM at 2933 MHz with CL21 latency and 1.2 V for laptops and NAS systems
This 16GB DDR4 2933MHz CL21 ECC SODIMM targets laptops, all-in-one systems and NAS units that require error-correcting memory. The unbuffered 260-pin module operates at 1.2V and meets JEDEC specifications for reliable operation in compatible micro servers and POS equipment.
The module is backward compatible with 2666MHz, 2400MHz and 2133MHz slots, so it can replace older DDR4 sticks in supported platforms. The upgrade is worthwhile when the system accepts ECC unbuffered memory and the workload benefits from the higher 2933MHz data rate and single 16GB capacity.
In most cases the SODIMM installs without tools by opening the memory door and seating the 260-pin module until the clips lock. The usual pitfalls are attempting to use the stick in non-ECC consumer laptops, mixing it with registered DIMMs, or exceeding the platform's maximum supported memory per slot.
| Brand | OWC |
|---|---|
| Part Number | 2C9D41R816GB |
| Capacity | 16GB |
| Type | 260-Pin DDR4 SO-DIMM |
| Speed | DDR4 2933 (PC4 23400) |
| CAS Latency | CL21 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Heat Spreader | No |
| Recommend Use | Laptops, All-in-One Systems, and NAS Systems |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
This module uses the standard 260-pin DDR4 SO-DIMM form factor. It fits any laptop or all-in-one system that accepts DDR4 SO-DIMMs and is backward compatible with 2666MHz, 2400MHz and 2133MHz slots.
Align the notch on the module's gold edge with the key in the slot, insert at a slight angle, then press down firmly until both side clips click into place. The step many miss is pushing hard enough to engage both clips fully.
No ongoing maintenance is needed. The module has no heat spreader and runs at 1.2V. If a future platform requires non-ECC memory, the module would need to be replaced, but the memory itself does not degrade differently from standard DDR4.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?