Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Ceramic heater cartridge 24V 40W 6mm diameter 20mm long 1000mm wires

3D Maker World

3D Maker World Ceramic Heater Cartridge 24V 40W 6mm 20mm 1000mm 3d printers accessory

SKU CH-CF26-53197

24 V 40 W ceramic heater cartridge with 6 mm diameter, 20 mm heated length and 1000 mm leads for hot-end upgrades

  • 24 V 40 W rating delivers consistent melt-zone temperature
  • 6 mm diameter × 20 mm heater fits standard hotend bores
  • 1000 mm lead wires allow flexible routing in any frame
  • Ceramic construction resists thermal cycling for reliable long prints

Ceramic Heater Cartridge 24V 40W

This ceramic heater cartridge is built for 3D printer hotends that require a 24V 40W heating element. It has a 6mm diameter and a 20mm heated length, with a 1000mm wire lead for flexible routing.

Voltage-specific hotend component

It suits printers designed for 24V 40W cartridges with these exact dimensions. Builders using a different voltage, wattage, diameter or heated length will need a different cartridge.

Helstu kostir

  • 24 V 40 W rating delivers consistent melt-zone temperature
  • 6 mm diameter × 20 mm heater fits standard hotend bores
  • 1000 mm lead wires allow flexible routing in any frame
  • Ceramic construction resists thermal cycling for reliable long prints

Tæknilýsing

Engin birt tæknilýsing fyrir þessa vöru enn.

Spurningar um þessa vöru

How can I confirm the 24V 40W ceramic heater cartridge is heating correctly after installation?

After wiring the cartridge to the printer's 24V supply, the hotend should reach the target temperature steadily and hold it within a few degrees during a test print.

What comes in the box and what must I supply separately for the 6mm 20mm cartridge with 1000mm leads?

The package contains the ceramic heater cartridge with 1000mm wires. You must provide a compatible 24V 40W hotend block, thermistor, mounting hardware and firmware configuration.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.