Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn
Ceramic heater cartridge 24V 40W 6mm diameter 20mm long 1000mm wires

3D Maker World

3D Maker World Ceramic Heater Cartridge 24V 40W 6mm 20mm 1000mm 3d printers accessory

SKU CH-CF26-53197

24 V 40 W ceramic heater cartridge with 6 mm diameter, 20 mm heated length and 1000 mm leads for hot-end upgrades

  • 24 V 40 W rating delivers consistent melt-zone temperature
  • 6 mm diameter × 20 mm heater fits standard hotend bores
  • 1000 mm lead wires allow flexible routing in any frame
  • Ceramic construction resists thermal cycling for reliable long prints

Ceramic Heater Cartridge 24V 40W

This ceramic heater cartridge is built for 3D printer hotends that require a 24V 40W heating element. It has a 6mm diameter and a 20mm heated length, with a 1000mm wire lead for flexible routing.

Voltage-specific hotend component

It suits printers designed for 24V 40W cartridges with these exact dimensions. Builders using a different voltage, wattage, diameter or heated length will need a different cartridge.

Høydepunkter

  • 24 V 40 W rating delivers consistent melt-zone temperature
  • 6 mm diameter × 20 mm heater fits standard hotend bores
  • 1000 mm lead wires allow flexible routing in any frame
  • Ceramic construction resists thermal cycling for reliable long prints

Spesifikasjoner

Ingen publiserte spesifikasjoner for denne varen ennå.

Spørsmål om denne varen

How can I confirm the 24V 40W ceramic heater cartridge is heating correctly after installation?

After wiring the cartridge to the printer's 24V supply, the hotend should reach the target temperature steadily and hold it within a few degrees during a test print.

What comes in the box and what must I supply separately for the 6mm 20mm cartridge with 1000mm leads?

The package contains the ceramic heater cartridge with 1000mm wires. You must provide a compatible 24V 40W hotend block, thermistor, mounting hardware and firmware configuration.

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.