Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.

Sledované položky Prihlásiť sa
Ceramic heater cartridge 24V 40W 6mm diameter 20mm long 1000mm wires

3D Maker World

3D Maker World Ceramic Heater Cartridge 24V 40W 6mm 20mm 1000mm 3d printers accessory

SKU CH-CF26-53197

24 V 40 W ceramic heater cartridge with 6 mm diameter, 20 mm heated length and 1000 mm leads for hot-end upgrades

  • 24 V 40 W rating delivers consistent melt-zone temperature
  • 6 mm diameter × 20 mm heater fits standard hotend bores
  • 1000 mm lead wires allow flexible routing in any frame
  • Ceramic construction resists thermal cycling for reliable long prints

Ceramic Heater Cartridge 24V 40W

This ceramic heater cartridge is built for 3D printer hotends that require a 24V 40W heating element. It has a 6mm diameter and a 20mm heated length, with a 1000mm wire lead for flexible routing.

Voltage-specific hotend component

It suits printers designed for 24V 40W cartridges with these exact dimensions. Builders using a different voltage, wattage, diameter or heated length will need a different cartridge.

Prednosti

  • 24 V 40 W rating delivers consistent melt-zone temperature
  • 6 mm diameter × 20 mm heater fits standard hotend bores
  • 1000 mm lead wires allow flexible routing in any frame
  • Ceramic construction resists thermal cycling for reliable long prints

Špecifikácie

Pre tento produkt zatiaľ nie sú zverejnené žiadne špecifikácie.

Otázky k tomuto produktu

How can I confirm the 24V 40W ceramic heater cartridge is heating correctly after installation?

After wiring the cartridge to the printer's 24V supply, the hotend should reach the target temperature steadily and hold it within a few degrees during a test print.

What comes in the box and what must I supply separately for the 6mm 20mm cartridge with 1000mm leads?

The package contains the ceramic heater cartridge with 1000mm wires. You must provide a compatible 24V 40W hotend block, thermistor, mounting hardware and firmware configuration.

Aj v tomto oddelení

Zákazníci tiež porovnávali

Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.