Acceptăm criptomonede — astfel, criptomonedele pe care le dețineți pot cumpăra echipamente reale.Plătiți în cripto, cheltuiți-o pe echipamente reale. Livrare asigurată gratuită oriunde în lume peste 399 $. Cartoane neutre, fără marcă, expediate din Germania.Livrare asigurată gratuită peste 399 $. Cursul dumneavoastră este blocat timp de 30 de minute de la deschiderea paginii de plată.Curs blocat 30 de minute. Fiecare articol este sigilat, numărul de serie este verificat, iar produsul este acoperit de o garanție de 24 de luni.Sigilat, garantat 24 de luni.

Produse urmărite Conectare
Ceramic heater cartridge 24V 40W 6mm diameter 20mm long 1000mm wires

3D Maker World

3D Maker World Ceramic Heater Cartridge 24V 40W 6mm 20mm 1000mm 3d printers accessory

SKU CH-CF26-53197

24 V 40 W ceramic heater cartridge with 6 mm diameter, 20 mm heated length and 1000 mm leads for hot-end upgrades

  • 24 V 40 W rating delivers consistent melt-zone temperature
  • 6 mm diameter × 20 mm heater fits standard hotend bores
  • 1000 mm lead wires allow flexible routing in any frame
  • Ceramic construction resists thermal cycling for reliable long prints

Ceramic Heater Cartridge 24V 40W

This ceramic heater cartridge is built for 3D printer hotends that require a 24V 40W heating element. It has a 6mm diameter and a 20mm heated length, with a 1000mm wire lead for flexible routing.

Voltage-specific hotend component

It suits printers designed for 24V 40W cartridges with these exact dimensions. Builders using a different voltage, wattage, diameter or heated length will need a different cartridge.

Puncte forte

  • 24 V 40 W rating delivers consistent melt-zone temperature
  • 6 mm diameter × 20 mm heater fits standard hotend bores
  • 1000 mm lead wires allow flexible routing in any frame
  • Ceramic construction resists thermal cycling for reliable long prints

Specificații

Nicio specificație publicată pentru acest articol deocamdată.

Întrebări despre acest articol

How can I confirm the 24V 40W ceramic heater cartridge is heating correctly after installation?

After wiring the cartridge to the printer's 24V supply, the hotend should reach the target temperature steadily and hold it within a few degrees during a test print.

What comes in the box and what must I supply separately for the 6mm 20mm cartridge with 1000mm leads?

The package contains the ceramic heater cartridge with 1000mm wires. You must provide a compatible 24V 40W hotend block, thermistor, mounting hardware and firmware configuration.

Tot din acest raion

Clienții au comparat și acestea.

Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.