Dogfish Technology mSATA-250GB internal SSD
- Internal Solid Stat…
- Consumer
Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.
Dogfish Technology
M.2 2242 form factor fits tight laptop slots, delivers 1TB capacity via SATA with 570 MBps read and 500 MBps write speeds
Options 1TB M.2 2242
This 1 TB internal SSD uses the M.2 2242 form factor and a SATA III interface to deliver solid-state storage in a 22 mm by 42 mm footprint. It is built with 3D NAND QLC memory and an SMI controller for everyday computing workloads. The drive suits ultra-thin laptops, small-form-factor desktops and embedded boards that cannot accept longer modules.
Confirm the host device has an M.2 socket that accepts 42 mm modules and is wired for SATA signalling rather than PCIe. Check the motherboard or laptop manual for keying type and maximum supported capacity. Ensure the BIOS or UEFI firmware recognises SATA SSDs in the M.2 slot and that no physical obstruction blocks the 3.2 mm module height.
Sustained sequential reads reach 570 MB/s and writes reach 500 MB/s when transferring large files over extended periods. The 3D NAND QLC architecture and SMI controller maintain consistent performance without thermal throttling within the 0 °C to 75 °C operating range. MTBF is rated at 1,000,000 hours for long-term reliability.
| Brand | THREE COLOUR DOGFISH |
|---|---|
| Series | 2242-1TB |
| Model | 2242-1TB |
| Device Type | Internal Solid State Drive (SSD) |
| Used For | Consumer |
| Form Factor | M.2 2242 |
| Capacity | 1TB |
| Memory Components | 3D NAND QLC |
| Interface | SATA III |
| Controller | SMI |
| Max Sequential Read | Up to 570 MBps |
| Max Sequential Write | Up to 500 MBps |
| MTBF | 1,000,000 hours |
| Operating Temperature | 0°C ~ +75°C |
| Storage Temperature | -45°C ~ +85°C |
| Operating Humidity | 0% ~ 95% |
| Height | 42MM |
| Width | 22mm |
| Depth | 3.2mm |
| Weight | 0.05g |
Aðrar útgáfur af þessari vöru
Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.
The drive is supplied as a bare M.2 2242 module. Most laptops and desktops include the single M2 screw; if yours is missing you will need to source one separately. No heatsink is required or included for this SATA III model.
QLC flash stores four bits per cell, so the 1TB capacity delivers the highest density in the 22mm x 42mm footprint. The SMI controller manages wear-levelling and SLC caching to keep the 570 MB/s read and 500 MB/s write figures consistent across the full capacity.
In a typical SATA III 6 Gb/s slot you will see sequential reads near 570 MB/s and writes near 500 MB/s on large files. Random 4K performance and sustained write speed after the SLC cache fills will be lower, but everyday boot and application loads remain well within SATA III limits.
Einnig í þessum vöruflokki
Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.
Það sem þú greiðir í, og það sem þú sérð verð í.
Sent úr veskinu þínu í greiðsluferlinu
Aðeins til skýringar — verð í vörulistanum eru í Bandaríkjadölum
Enginn gjaldmiðill passar við það.
Veldu tungumálið sem síðan talar við þig á.
Fyrsta heimsókn?
Áttu þegar aðgang?
Það er engin sjálfvirk endurstilling: þessi verslun sendir engan tölvupóst, svo það er enginn einnota tengill til að biðja um. Skildu netfangið eftir á aðganginum og einhver sinnir því handvirkt.
Beiðni skráð
Ekkert er á leiðinni í pósthólfið þitt — þessi verslun sendir engan tölvupóst. Einhver sinnir þessu handvirkt.
Mundir þú það?