Dogfish Technology mSATA-250GB internal SSD
- Internal Solid Stat…
- Consumer
Vi tar emot kryptovaluta — så att kryptot du äger kan köpa riktig hårdvara.Betala med krypto, använd det till riktig hårdvara. Fri, försäkrad frakt över hela världen vid köp över 399 $. Neutrala, omärkta ytterkartonger, skickade från Tyskland.Fri, försäkrad frakt över 399 $. Din kurs låses i 30 minuter så snart kassan öppnas.Kursen låst i 30 minuter. Varje artikel är förseglad, har kontrollerat serienummer och täcks av 24 månaders garanti.Förseglad, 24 månaders garanti.
Dogfish Technology
M.2 2242 form factor fits tight laptop slots, delivers 1TB capacity via SATA with 570 MBps read and 500 MBps write speeds
Options 1TB M.2 2242
This 1 TB internal SSD uses the M.2 2242 form factor and a SATA III interface to deliver solid-state storage in a 22 mm by 42 mm footprint. It is built with 3D NAND QLC memory and an SMI controller for everyday computing workloads. The drive suits ultra-thin laptops, small-form-factor desktops and embedded boards that cannot accept longer modules.
Confirm the host device has an M.2 socket that accepts 42 mm modules and is wired for SATA signalling rather than PCIe. Check the motherboard or laptop manual for keying type and maximum supported capacity. Ensure the BIOS or UEFI firmware recognises SATA SSDs in the M.2 slot and that no physical obstruction blocks the 3.2 mm module height.
Sustained sequential reads reach 570 MB/s and writes reach 500 MB/s when transferring large files over extended periods. The 3D NAND QLC architecture and SMI controller maintain consistent performance without thermal throttling within the 0 °C to 75 °C operating range. MTBF is rated at 1,000,000 hours for long-term reliability.
| Brand | THREE COLOUR DOGFISH |
|---|---|
| Series | 2242-1TB |
| Model | 2242-1TB |
| Device Type | Internal Solid State Drive (SSD) |
| Used For | Consumer |
| Form Factor | M.2 2242 |
| Capacity | 1TB |
| Memory Components | 3D NAND QLC |
| Interface | SATA III |
| Controller | SMI |
| Max Sequential Read | Up to 570 MBps |
| Max Sequential Write | Up to 500 MBps |
| MTBF | 1,000,000 hours |
| Operating Temperature | 0°C ~ +75°C |
| Storage Temperature | -45°C ~ +85°C |
| Operating Humidity | 0% ~ 95% |
| Height | 42MM |
| Width | 22mm |
| Depth | 3.2mm |
| Weight | 0.05g |
Andra versioner av den här modellen
Samma familj, men olika minne, kylning eller klockfrekvens — jämför innan du bestämmer dig.
The drive is supplied as a bare M.2 2242 module. Most laptops and desktops include the single M2 screw; if yours is missing you will need to source one separately. No heatsink is required or included for this SATA III model.
QLC flash stores four bits per cell, so the 1TB capacity delivers the highest density in the 22mm x 42mm footprint. The SMI controller manages wear-levelling and SLC caching to keep the 570 MB/s read and 500 MB/s write figures consistent across the full capacity.
In a typical SATA III 6 Gb/s slot you will see sequential reads near 570 MB/s and writes near 500 MB/s on large files. Random 4K performance and sustained write speed after the SLC cache fills will be lower, but everyday boot and application loads remain well within SATA III limits.
Även i den här avdelningen
Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.
Det du betalar med, och det du ser priserna i.
Skickas från din plånbok i kassan
Endast visning — katalogen är prissatt i US-dollar
Ingen valuta matchar.
Välj det språk du vill att webbplatsen ska visas på.
Ny här?
Har du redan ett konto?
Det finns ingen automatisk återställning: den här butiken skickar inga e-postmeddelanden, så det finns ingen engångslänk att begära. Lämna adressen kopplad till kontot, så hanteras den för hand.
Förfrågan noterad
Inget är på väg till din inkorg — den här butiken skickar aldrig e-post. Någon tar hand om detta manuellt.
Kom du på det?