Dogfish Technology mSATA-250GB internal SSD
- Internal Solid Stat…
- Consumer
Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.
Dogfish Technology
M.2 2242 form factor fits tight laptop slots, delivers 1TB capacity via SATA with 570 MBps read and 500 MBps write speeds
Options 1TB M.2 2242
This 1 TB internal SSD uses the M.2 2242 form factor and a SATA III interface to deliver solid-state storage in a 22 mm by 42 mm footprint. It is built with 3D NAND QLC memory and an SMI controller for everyday computing workloads. The drive suits ultra-thin laptops, small-form-factor desktops and embedded boards that cannot accept longer modules.
Confirm the host device has an M.2 socket that accepts 42 mm modules and is wired for SATA signalling rather than PCIe. Check the motherboard or laptop manual for keying type and maximum supported capacity. Ensure the BIOS or UEFI firmware recognises SATA SSDs in the M.2 slot and that no physical obstruction blocks the 3.2 mm module height.
Sustained sequential reads reach 570 MB/s and writes reach 500 MB/s when transferring large files over extended periods. The 3D NAND QLC architecture and SMI controller maintain consistent performance without thermal throttling within the 0 °C to 75 °C operating range. MTBF is rated at 1,000,000 hours for long-term reliability.
| Brand | THREE COLOUR DOGFISH |
|---|---|
| Series | 2242-1TB |
| Model | 2242-1TB |
| Device Type | Internal Solid State Drive (SSD) |
| Used For | Consumer |
| Form Factor | M.2 2242 |
| Capacity | 1TB |
| Memory Components | 3D NAND QLC |
| Interface | SATA III |
| Controller | SMI |
| Max Sequential Read | Up to 570 MBps |
| Max Sequential Write | Up to 500 MBps |
| MTBF | 1,000,000 hours |
| Operating Temperature | 0°C ~ +75°C |
| Storage Temperature | -45°C ~ +85°C |
| Operating Humidity | 0% ~ 95% |
| Height | 42MM |
| Width | 22mm |
| Depth | 3.2mm |
| Weight | 0.05g |
Andre versjoner av denne modellen
Samme familie, annet minne, annen kjøler eller klokkefrekvens — sammenlign før du bestemmer deg.
The drive is supplied as a bare M.2 2242 module. Most laptops and desktops include the single M2 screw; if yours is missing you will need to source one separately. No heatsink is required or included for this SATA III model.
QLC flash stores four bits per cell, so the 1TB capacity delivers the highest density in the 22mm x 42mm footprint. The SMI controller manages wear-levelling and SLC caching to keep the 570 MB/s read and 500 MB/s write figures consistent across the full capacity.
In a typical SATA III 6 Gb/s slot you will see sequential reads near 570 MB/s and writes near 500 MB/s on large files. Random 4K performance and sustained write speed after the SLC cache fills will be lower, but everyday boot and application loads remain well within SATA III limits.
Også i denne avdelingen
Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.
Det du betaler med, og det du ser prisene i.
Sendes fra lommeboken din i kassen
Kun visning — katalogen er prissatt i USD
Fant ingen valuta.
Velg språket nettstedet snakker til deg på.
Ny her?
Har du allerede en konto?
Det finnes ingen automatisk tilbakestilling: butikken sender ikke e-post, så det finnes ingen engangslenke å be om. La adressen stå på kontoen, så blir den behandlet manuelt.
Forespørsel registrert
Ingenting er på vei til innboksen din — butikken sender ingen e-post i det hele tatt. Noen behandler dette manuelt.
Husket du det likevel?