Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Green circuit board with black memory chips and gold edge connector

NEMIX RAM

NEMIX RAM 8GB DDR4 3200 PC4-25600 ECC RDIMM 1Rx8 CL22 1.2V 288-Pin Supermicro H11SSL-NC EPYC memory upgrade

SKU CH-NAS1-33NWQ

An 8 GB DDR4 3200 ECC registered DIMM built for Supermicro H11SSL-NC EPYC motherboards

  • Capacity8GB
  • SpeedDDR4 3200 (PC4 25600)
  • ECCYes
  • Buffered/RegisteredRegistered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • ECC protection prevents data errors in critical workloads
  • Registered design stabilises signal integrity for server platforms
  • 3200 MT/s throughput matches EPYC memory controller specs
  • 2 V operation reduces power draw per module
  • Validated compatibility with Supermicro H11SSL-NC motherboards

Server ECC RDIMM Upgrade

This 8GB DDR4 3200 registered DIMM adds ECC-protected capacity to a Supermicro H11SSL-NC motherboard running AMD EPYC processors. The module operates at 1.2V with CL22 latency and uses a single-rank 1Rx8 organisation for broad slot compatibility.

Replaces Slower or Smaller Modules

Upgrading from lower-speed DDR4 or non-ECC unbuffered memory is worthwhile when the workload demands error correction and registered signalling for multi-DIMM stability. The jump makes sense for virtualisation hosts, database nodes or NAS appliances that hit capacity limits on the existing configuration.

Tool-Free Slot Installation

The 288-pin RDIMM seats in the standard DDR4 slot without cables or brackets; align the notch, press evenly until the retention clips engage, then verify detection in BIOS. Common issues include mixing registered and unbuffered DIMMs in the same channel or exceeding the per-channel rank limit documented in the motherboard manual.

Helstu kostir

  • ECC protection prevents data errors in critical workloads
  • Registered design stabilises signal integrity for server platforms
  • 3200 MT/s throughput matches EPYC memory controller specs
  • 2 V operation reduces power draw per module
  • Validated compatibility with Supermicro H11SSL-NC motherboards

Tæknilýsing

BrandNEMIX RAM
SeriesSuperMicro Server/Workstation Compatible Series Memory
ModelSuperMicro DDR4 3200MHZ ECC RDIMM Registered Server Memory
Part NumberMR25600-818K1
Capacity8GB
SpeedDDR4 3200 (PC4 25600)
ECCYes
Buffered/RegisteredRegistered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemSupermicro
CAS LatencyCL22
Heat SpreaderNo
Type288-Pin DDR4 RDIMM
Rank1Rx8
FeaturesDDR4 ECC Registered RDIMM Server Motherboard Compatible
Package Content8GB (1X8GB) DDR4 3200MHZ PC4-25600 1Rx8 1.2V CL22 288-PIN ECC RDIMM Registered Server Memory

Spurningar um þessa vöru

Does the 288-pin RDIMM fit a Supermicro H11SSL-NC motherboard?

The 288-pin DDR4 RDIMM form factor matches the memory slots on the Supermicro H11SSL-NC AMD EPYC series motherboard.

What is the correct way to seat the 1Rx8 ECC registered module?

Align the notch with the slot key, press down firmly until both retention clips click, then verify the system registers 8 GB at 3200 MT/s with ECC active.

When should the module be replaced if ECC starts logging correctable errors?

Replace the stick once the platform firmware reports a rising correctable-error count that exceeds the vendor threshold, as the 1.20 V DDR4 chips cannot be serviced in place.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.