暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Green circuit board with black memory chips and gold edge connector

NEMIX RAM

NEMIX RAM 8GB DDR4 3200 PC4-25600 ECC RDIMM 1Rx8 CL22 1.2V 288-Pin Supermicro H11SSL-NC EPYC memory upgrade

SKU CH-NAS1-33NWQ

An 8 GB DDR4 3200 ECC registered DIMM built for Supermicro H11SSL-NC EPYC motherboards

  • Capacity8GB
  • SpeedDDR4 3200 (PC4 25600)
  • ECCYes
  • Buffered/RegisteredRegistered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • ECC protection prevents data errors in critical workloads
  • Registered design stabilises signal integrity for server platforms
  • 3200 MT/s throughput matches EPYC memory controller specs
  • 2 V operation reduces power draw per module
  • Validated compatibility with Supermicro H11SSL-NC motherboards

Server ECC RDIMM Upgrade

This 8GB DDR4 3200 registered DIMM adds ECC-protected capacity to a Supermicro H11SSL-NC motherboard running AMD EPYC processors. The module operates at 1.2V with CL22 latency and uses a single-rank 1Rx8 organisation for broad slot compatibility.

Replaces Slower or Smaller Modules

Upgrading from lower-speed DDR4 or non-ECC unbuffered memory is worthwhile when the workload demands error correction and registered signalling for multi-DIMM stability. The jump makes sense for virtualisation hosts, database nodes or NAS appliances that hit capacity limits on the existing configuration.

Tool-Free Slot Installation

The 288-pin RDIMM seats in the standard DDR4 slot without cables or brackets; align the notch, press evenly until the retention clips engage, then verify detection in BIOS. Common issues include mixing registered and unbuffered DIMMs in the same channel or exceeding the per-channel rank limit documented in the motherboard manual.

特長

  • ECC protection prevents data errors in critical workloads
  • Registered design stabilises signal integrity for server platforms
  • 3200 MT/s throughput matches EPYC memory controller specs
  • 2 V operation reduces power draw per module
  • Validated compatibility with Supermicro H11SSL-NC motherboards

仕様

BrandNEMIX RAM
SeriesSuperMicro Server/Workstation Compatible Series Memory
ModelSuperMicro DDR4 3200MHZ ECC RDIMM Registered Server Memory
Part NumberMR25600-818K1
Capacity8GB
SpeedDDR4 3200 (PC4 25600)
ECCYes
Buffered/RegisteredRegistered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemSupermicro
CAS LatencyCL22
Heat SpreaderNo
Type288-Pin DDR4 RDIMM
Rank1Rx8
FeaturesDDR4 ECC Registered RDIMM Server Motherboard Compatible
Package Content8GB (1X8GB) DDR4 3200MHZ PC4-25600 1Rx8 1.2V CL22 288-PIN ECC RDIMM Registered Server Memory

この商品に関する質問

Does the 288-pin RDIMM fit a Supermicro H11SSL-NC motherboard?

The 288-pin DDR4 RDIMM form factor matches the memory slots on the Supermicro H11SSL-NC AMD EPYC series motherboard.

What is the correct way to seat the 1Rx8 ECC registered module?

Align the notch with the slot key, press down firmly until both retention clips click, then verify the system registers 8 GB at 3200 MT/s with ECC active.

When should the module be replaced if ECC starts logging correctable errors?

Replace the stick once the platform firmware reports a rising correctable-error count that exceeds the vendor threshold, as the 1.20 V DDR4 chips cannot be serviced in place.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。