Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Two green DDR3L SODIMM sticks with gold contacts

OWC

OWC 16GB (2x8GB) DDR3L 1600 CL11 1.35V SODIMM kit for Synology DS1817+ RS818+ RS818RP+ RS1219+

SKU CH-5YN3-QKGR6

16 GB DDR3L 1600 SODIMM kit (2 × 8 GB, CL11, 1.35 V) validated for Synology DS1817+, RS818+, RS818RP+ and RS1219+ NAS models

  • Capacity16GB (2 x 8GB)
  • Type204-Pin DDR3L Non-ECC SODIMM
  • SpeedDDR3L 1600 (PC3L 12800)
  • CAS LatencyCL11
  • Voltage1.35V
  • ECCNo

Capacity 16GB (2 x 8GB)

  • 16 GB kit expands NAS capacity for heavier workloads
  • DDR3L 1600 CL11 1.35 V matches Synology DS1817+ RS818+ RS818RP+ RS1219+ specs
  • JEDEC and RoHS compliant for warranty-safe upgrades
  • 204-pin SODIMM form factor fits the four supported NAS models
  • Two 8 GB unbuffered non-ECC modules install as a matched pair

Synology NAS DDR3L kit

This 16GB kit contains two 8GB DDR3L SODIMM modules rated at 1600MHz with CL11 latency. It is built for Synology DS1817+, RS818+, RS818RP+ and RS1219+ units that accept 204-pin laptop memory. The modules run at 1.35V and are unbuffered non-ECC.

204-pin DDR3L 1.35V SODIMM

The decisive specification is the 204-pin DDR3L form factor at 1.35V. Systems requiring standard 1.5V DDR3, registered DIMMs, ECC modules or a different pin count will not accept these sticks. Verify the slot type before ordering.

NAS owners needing 16GB total

This kit suits administrators expanding a compatible Synology NAS to 16GB using matched pairs. Builders needing ECC protection, registered memory, higher capacities per slot, or a different voltage should look elsewhere.

Helstu kostir

  • 16 GB kit expands NAS capacity for heavier workloads
  • DDR3L 1600 CL11 1.35 V matches Synology DS1817+ RS818+ RS818RP+ RS1219+ specs
  • JEDEC and RoHS compliant for warranty-safe upgrades
  • 204-pin SODIMM form factor fits the four supported NAS models
  • Two 8 GB unbuffered non-ECC modules install as a matched pair

Tæknilýsing

BrandOWC
Part Number1S6T32R8016P
Capacity16GB (2 x 8GB)
Type204-Pin DDR3L Non-ECC SODIMM
SpeedDDR3L 1600 (PC3L 12800)
CAS LatencyCL11
Voltage1.35V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
Heat SpreaderNo
Compatible SystemSynology NAS DS1817+
Synology NAS RS818+
Synology NAS RS818RP+
Synology NAS RS1219+

Aðrar útgáfur af þessari vöru

5 í viðbót í sama vöruflokki

Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.

Spurningar um þessa vöru

What does the 1600 MHz speed mean when the kit is installed in a Synology NAS?

The modules run at DDR3L 1600 (PC3L-12800) with CL11 latency, delivering the rated bandwidth the NAS memory controller supports.

How does the DDR3L 204-pin SODIMM interface limit the upgrade?

The kit uses the 204-pin DDR3L SODIMM standard at 1.35 V, so it only fits slots that accept DDR3L low-voltage modules.

What physical space is needed to install the two 8 GB sticks?

Each module is a standard 204-pin SODIMM without a heat spreader, requiring two adjacent SO-DIMM sockets in the NAS chassis.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.