Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Black rackmount SATA duplicator with four front drive slots and LCD screen

Systor

Systor SYS304RMHDD-DP 1-to-4 SATA Duplicator 300MB/s

SKU CH-XPKY-NE105

Standalone rackmount duplicator copies or sanitises up to four SATA drives at 300 MB/s without a host computer

  • TypeHDD Duplicator
  • Target1 to 4
  • Buffer Memory128M
  • Supported MediaFAT16/32, NTFS, Linux(EXT2/EXT3/EXT4)
  • Data Transfer Rate300MB/s
  • Language SupportEnglish or Japanese

DATA TRANSFER RATE Rackmount - 18.0GB/min [300MB/sec]

Yfirstrikaðar útgáfur eru til, en ekki til hér.

TARGET SIZE 1 to 04

Yfirstrikaðar útgáfur eru til, en ekki til hér.

  • Standalone operation with no PC required
  • Copies up to four drives at 300 MB/s
  • Quick-copy FAT, NTFS and Linux partitions
  • DoD 5220.22-M compliant sanitisation modes
  • Supports 2.5 and 3.5 inch drives adapter-free

Rackmount SATA Duplicator 1-to-4

The Systor SYS304RMHDD-DP is a standalone rackmount duplicator that copies one SATA source drive to up to four target drives at once. It operates without a host computer and reaches a transfer rate of 300MB/s. The unit supports both 3.5" and 2.5" hard drives or solid-state drives without extra adapters. A 128MB buffer helps sustain throughput during simultaneous duplication.

For IT teams sanitising or cloning SATA drives

This duplicator suits organisations that need quick, standalone cloning of FAT16, FAT32, NTFS or Linux EXT2/EXT3/EXT4 volumes, plus whole-media copies of any format. It also provides DoD 5220.22-M compliant sanitisation for secure erase requirements. It is not for environments that require more than four targets per run, or for workflows that depend on interfaces other than SATA.

300MB/s SATA transfer rate decides fit

The single specification that determines suitability is the 300MB/s maximum copy speed across all four ports. If your project demands higher throughput or non-SATA connectivity, this model will not meet the requirement.

Helstu kostir

  • Standalone operation with no PC required
  • Copies up to four drives at 300 MB/s
  • Quick-copy FAT, NTFS and Linux partitions
  • DoD 5220.22-M compliant sanitisation modes
  • Supports 2.5 and 3.5 inch drives adapter-free

Tæknilýsing

BrandSystor
ModelSYS304RMHDD-DP
TypeHDD Duplicator
Target1 to 4
Buffer Memory128M
Supported MediaFAT16/32, NTFS, Linux(EXT2/EXT3/EXT4)
Data Transfer Rate300MB/s
Language SupportEnglish or Japanese
DisplayLCD Screen
Operating TypeStandalone
Panel ColorBlack
Load TypeSlot
FeaturesQuick Copy: FAT16/32, NTFS, Linux(EXT2/EXT3/EXT4) Whole Media Copy: All Formats
Environmental SpecOperating Humidity: 15% ~ 90%

Aðrar útgáfur af þessari vöru

5 í viðbót í sama vöruflokki

Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.

Spurningar um þessa vöru

How do I install drives in the Systor SYS304RMHDD-DP and what step is often missed?

Insert each 2.5 or 3.5 SATA drive directly into a slot — no adapter needed — then verify the LCD shows every target detected before starting a copy job.

What maintenance or replacement will the duplicator need over time?

The 40 mm rear fans and per-port outtake fans should be cleaned regularly and replaced if airflow drops, while the power supply is built for continuous operation.

What limit appears first during sustained duplication on this unit?

The 300 MB per second transfer ceiling (18 GB per minute) is the bottleneck; buffer memory is 128 MB and the DoD 5220.22-M erase passes add further time.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.