Systor 662712130484 1:5 SATA Hard Drive Duplicator & Sanitizer
- Hard Drive Duplicat…
- 1 to 5
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
Systor
Standalone rackmount duplicator copies or sanitises up to four SATA drives at 300 MB/s without a host computer
DATA TRANSFER RATE Rackmount - 18.0GB/min [300MB/sec]
Yliviivatut versiot ovat olemassa, mutta niitä ei ole varastossa täällä.
Yliviivatut versiot ovat olemassa, mutta niitä ei ole varastossa täällä.
The Systor SYS304RMHDD-DP is a standalone rackmount duplicator that copies one SATA source drive to up to four target drives at once. It operates without a host computer and reaches a transfer rate of 300MB/s. The unit supports both 3.5" and 2.5" hard drives or solid-state drives without extra adapters. A 128MB buffer helps sustain throughput during simultaneous duplication.
This duplicator suits organisations that need quick, standalone cloning of FAT16, FAT32, NTFS or Linux EXT2/EXT3/EXT4 volumes, plus whole-media copies of any format. It also provides DoD 5220.22-M compliant sanitisation for secure erase requirements. It is not for environments that require more than four targets per run, or for workflows that depend on interfaces other than SATA.
The single specification that determines suitability is the 300MB/s maximum copy speed across all four ports. If your project demands higher throughput or non-SATA connectivity, this model will not meet the requirement.
| Brand | Systor |
|---|---|
| Model | SYS304RMHDD-DP |
| Type | HDD Duplicator |
| Target | 1 to 4 |
| Buffer Memory | 128M |
| Supported Media | FAT16/32, NTFS, Linux(EXT2/EXT3/EXT4) |
| Data Transfer Rate | 300MB/s |
| Language Support | English or Japanese |
| Display | LCD Screen |
| Operating Type | Standalone |
| Panel Color | Black |
| Load Type | Slot |
| Features | Quick Copy: FAT16/32, NTFS, Linux(EXT2/EXT3/EXT4) Whole Media Copy: All Formats |
| Environmental Spec | Operating Humidity: 15% ~ 90% |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Insert each 2.5 or 3.5 SATA drive directly into a slot — no adapter needed — then verify the LCD shows every target detected before starting a copy job.
The 40 mm rear fans and per-port outtake fans should be cleaned regularly and replaced if airflow drops, while the power supply is built for continuous operation.
The 300 MB per second transfer ceiling (18 GB per minute) is the bottleneck; buffer memory is 128 MB and the DoD 5220.22-M erase passes add further time.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?