Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.

Sledované položky Prihlásiť sa

Systor

Systor SYS304RMHDD-DP 1-to-4 SATA Duplicator 300MB/s

SKU CH-XPKY-NE105

Standalone rackmount duplicator copies or sanitises up to four SATA drives at 300 MB/s without a host computer

  • TypeHDD Duplicator
  • Target1 to 4
  • Buffer Memory128M
  • Supported MediaFAT16/32, NTFS, Linux(EXT2/EXT3/EXT4)
  • Data Transfer Rate300MB/s
  • Language SupportEnglish or Japanese

DATA TRANSFER RATE Rackmount - 18.0GB/min [300MB/sec]

Preškrtnuté verzie existujú, ale nie sú tu skladom.

TARGET SIZE 1 to 04

Preškrtnuté verzie existujú, ale nie sú tu skladom.

  • Standalone operation with no PC required
  • Copies up to four drives at 300 MB/s
  • Quick-copy FAT, NTFS and Linux partitions
  • DoD 5220.22-M compliant sanitisation modes
  • Supports 2.5 and 3.5 inch drives adapter-free

Rackmount SATA Duplicator 1-to-4

The Systor SYS304RMHDD-DP is a standalone rackmount duplicator that copies one SATA source drive to up to four target drives at once. It operates without a host computer and reaches a transfer rate of 300MB/s. The unit supports both 3.5" and 2.5" hard drives or solid-state drives without extra adapters. A 128MB buffer helps sustain throughput during simultaneous duplication.

For IT teams sanitising or cloning SATA drives

This duplicator suits organisations that need quick, standalone cloning of FAT16, FAT32, NTFS or Linux EXT2/EXT3/EXT4 volumes, plus whole-media copies of any format. It also provides DoD 5220.22-M compliant sanitisation for secure erase requirements. It is not for environments that require more than four targets per run, or for workflows that depend on interfaces other than SATA.

300MB/s SATA transfer rate decides fit

The single specification that determines suitability is the 300MB/s maximum copy speed across all four ports. If your project demands higher throughput or non-SATA connectivity, this model will not meet the requirement.

Prednosti

  • Standalone operation with no PC required
  • Copies up to four drives at 300 MB/s
  • Quick-copy FAT, NTFS and Linux partitions
  • DoD 5220.22-M compliant sanitisation modes
  • Supports 2.5 and 3.5 inch drives adapter-free

Špecifikácie

BrandSystor
ModelSYS304RMHDD-DP
TypeHDD Duplicator
Target1 to 4
Buffer Memory128M
Supported MediaFAT16/32, NTFS, Linux(EXT2/EXT3/EXT4)
Data Transfer Rate300MB/s
Language SupportEnglish or Japanese
DisplayLCD Screen
Operating TypeStandalone
Panel ColorBlack
Load TypeSlot
FeaturesQuick Copy: FAT16/32, NTFS, Linux(EXT2/EXT3/EXT4) Whole Media Copy: All Formats
Environmental SpecOperating Humidity: 15% ~ 90%

Ďalšie verzie tohto modelu

Ďalších 5 v tomto rade

Rovnaký rad, iná pamäť, chladič alebo frekvencia — porovnajte pred rozhodnutím.

Otázky k tomuto produktu

How do I install drives in the Systor SYS304RMHDD-DP and what step is often missed?

Insert each 2.5 or 3.5 SATA drive directly into a slot — no adapter needed — then verify the LCD shows every target detected before starting a copy job.

What maintenance or replacement will the duplicator need over time?

The 40 mm rear fans and per-port outtake fans should be cleaned regularly and replaced if airflow drops, while the power supply is built for continuous operation.

What limit appears first during sustained duplication on this unit?

The 300 MB per second transfer ceiling (18 GB per minute) is the bottleneck; buffer memory is 128 MB and the DoD 5220.22-M erase passes add further time.

Aj v tomto oddelení

Zákazníci tiež porovnávali

Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.