Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.

Sledované položky Prihlásiť sa
Black standalone tower with eleven vertical SATA drive slots and four-button control panel

Acumen Disc

Acumen Disc H11-SATA150 1-to-11 SATA Duplicator 150MB/s

SKU CH-TBSB-281KY

Standalone SATA duplicator copies up to 11 drives at 150 MB/s with DoD-compliant erase modes

  • TypeHard Drive Duplicator
  • Target1 to 11
  • Supported MediaSATA Hard Drive Disk / SATA Solid State Drive
  • Data Transfer Rate150MB/s
  • Operating TypeStandalone
  • ConnectorSATA

Target 1 to 11

Data Transfer Rate 150MB/s

  • Copies up to 11 SATA drives simultaneously
  • Standalone 4-button controller needs no host PC
  • 150 MB/s transfer rate duplicates 9 GB per minute
  • DoD-compliant sanitiser with four erase modes
  • Accepts 3.5" and 2.5" SATA HDDs and SSDs

Eleven-target standalone duplicator

This Acumen Disc unit copies one source SATA drive to eleven targets at once. It accepts 3.5-inch and 2.5-inch hard drives or solid-state drives directly in its slot-load bays. No host computer is required because the four-button controller runs every function locally.

Replaces single-bay docks and software clones

A USB dock copies one drive at a time and relies on host software. This duplicator removes that bottleneck by writing to eleven targets simultaneously at up to 150 megabytes per second. The jump is worth it when you regularly image batches of drives for deployment, recovery or forensic work.

No capacity ceiling on SATA media

The duplicator copies the full bit-stream of any SATA hard drive or SSD regardless of total capacity. Quick-copy mode can duplicate only used sectors to save time, while sector-by-sector mode clones every block. Throughput tops out at the SATA I limit of 150 megabytes per second, so faster SATA II or III drives will not exceed that rate.

Prednosti

  • Copies up to 11 SATA drives simultaneously
  • Standalone 4-button controller needs no host PC
  • 150 MB/s transfer rate duplicates 9 GB per minute
  • DoD-compliant sanitiser with four erase modes
  • Accepts 3.5" and 2.5" SATA HDDs and SSDs

Špecifikácie

BrandAcumen Disc
Part NumberH11-SATA150
TypeHard Drive Duplicator
Target1 to 11
Supported MediaSATA Hard Drive Disk / SATA Solid State Drive
Data Transfer Rate150MB/s
Operating TypeStandalone
ConnectorSATA
Load TypeSlot
Power SupplyAC: 115-230 V, 50/60 Hz

Ďalšie verzie tohto modelu

Ďalších 5 v tomto rade

Rovnaký rad, iná pamäť, chladič alebo frekvencia — porovnajte pred rozhodnutím.

Otázky k tomuto produktu

How many SATA drives can the H11-SATA150 duplicator hold at once?

The unit accepts one source and up to eleven target drives simultaneously for a total of twelve SATA devices.

What is the correct way to load a 2.5-inch SSD into the slot-load bays?

Insert the SSD directly into the slot; the supplier notes that 2.5-inch SATA SSDs fit without an adapter, while 3.5-inch HDDs use the provided adapter.

Which erase modes are available for later sanitisation of drives copied on this duplicator?

Four erase modes are built in, including a DoD-compliant erase that runs during whole-media copy operations.

Aj v tomto oddelení

Zákazníci tiež porovnávali

Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.