Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Black 97mm blower fan with 3-wire power connector

Zyvpee

Zyvpee F9733B12LE 97mm 12V 0.72A 3-wire blower case fan

SKU CH-YDXY-FVQJC

A 97 mm blower fan with a 3-wire power connector runs on 12 V and draws 0.72 A

  • TypeCase Fan
  • CompatibilityCase
  • Fan Size100mm
  • Bearing TypeBall
  • Power Connector3 wires
  • ColorBlack
  • Blower design targets airflow through tight spaces
  • 12 V 0.72 A draws modest power from a 3-wire header
  • Ball bearing supports continuous operation with reduced friction
  • 97 mm by 33 mm frame fits compact 100 mm mounts
  • Non-LED black finish keeps the build visually clean

Compact blower for tight cases

The Zyvpee F9733B12LE is a 97 mm by 33 mm blower fan built for small-form-factor cases. It runs on 12 V and draws 0.72 A through a standard 3-wire power connector. The ball-bearing motor and non-LED black frame suit builders who need directed airflow without lighting.

Replaces larger axial fans when space is limited

Swap this blower in when a 100 mm axial fan cannot fit or when components block straight-through airflow. The 10 cm blower wheel pushes air across heatsinks and voltage-regulator zones that traditional fans miss. The upgrade is worth it when clearance is under 33 mm or when ducting is required.

Simple three-wire fit with polarity care

Mount the 97 mm square frame using the four corner holes and plug the 3-wire connector into any 12 V fan header. The 10 cm lead is short, so plan routing before final assembly. The common mistake is reversing the yellow sense wire, which stops speed reporting but not rotation.

Helstu kostir

  • Blower design targets airflow through tight spaces
  • 12 V 0.72 A draws modest power from a 3-wire header
  • Ball bearing supports continuous operation with reduced friction
  • 97 mm by 33 mm frame fits compact 100 mm mounts
  • Non-LED black finish keeps the build visually clean

Tæknilýsing

BrandZyvpee
SeriesF9733
ModelF9733B12LE
TypeCase Fan
CompatibilityCase
Fan Size100mm
Bearing TypeBall
Power Connector3 wires
ColorBlack
LEDNon-LED
FeaturesDC blower
Dimensions97 * 33mm
Package Contentsrefer to title

Spurningar um þessa vöru

Will the 97 mm by 33 mm frame fit my case's blower slot?

The fan measures 97 mm square by 33 mm thick, so verify your case has a matching cut-out and mounting holes before ordering.

How do I connect the 3-wire power lead correctly?

Plug the 3-wire connector into a 12 V fan header on the motherboard or controller; the third wire carries the tachometer signal for speed monitoring.

When should I expect to service the ball bearing?

Ball bearings typically run for years; clean dust from the blower fins periodically and replace the fan if noise or vibration increases.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.