BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Kami menerima kripto — jadi koin yang anda simpan boleh membeli perkakasan sebenar.Bayar dengan kripto, belanjakannya untuk perkakasan sebenar. Penghantaran berinsurans percuma ke seluruh dunia untuk belian melebihi USD 399. Kotak biasa tanpa jenama, dihantar dari Jerman.Penghantaran berinsurans percuma untuk belian melebihi USD 399. Kadar anda dikunci selama 30 minit sebaik sahaja proses pesanan bermula.Kadar dikunci selama 30 minit. Setiap item disegel, nombor sirinya disemak, dan dilindungi waranti 24 bulan.Disegel, waranti 24 bulan.
NEMIX RAM
An 8 GB DDR3 SODIMM running at 1066 MHz with CL7 latency and 1.5 V for laptop upgrades
This 8GB module uses 204-pin DDR3 technology running at 1066MHz with a CL7 latency. It targets laptops, all-in-one PCs, small-form-factor systems and NAS devices that accept PC3-8500 unbuffered non-ECC memory. The single-stick design leaves other slots free for future expansion.
Operating at 1.50V, the module draws typical DDR3 power without a heat spreader, relying on the system's existing airflow. Unbuffered non-ECC construction keeps electrical load low for the memory controller. Acoustic profile is silent because there are no moving parts on the stick itself.
The 8GB density is delivered through a 2Rx8 organisation, which determines compatibility with the memory controller's rank limits. Systems that only support single-rank modules or that cap total memory below 8GB per slot cannot use this stick. Verify the platform's maximum rank and per-slot capacity before purchase.
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM DDR3 Orignial Series 204-Pin NON-ECC Unbuffered SODIMM Memory |
| Model | DDR3 NON- ECC Unbuffered SODIMM Laptop, AIO, SFF, NAS Storage Device Memory |
| Part Number | MS8500-828K1 |
| Capacity | 8GB |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3 1066 (PC3 8500) |
| CAS Latency | CL7 |
| Voltage | 1.50V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Heat Spreader | No |
| Features | DDR3 Laptop, AIO All-in-One, SFF, NAS Device Compatible |
Power off the laptop, remove the battery if possible, open the memory compartment, align the notch on the module with the slot key, insert at an angle then press down until the clips click. The step people miss is fully seating both clips before closing the case.
No scheduled maintenance is required; the module has no heat spreader and runs at 1.5V. If a memory error appears, run a diagnostic and replace the stick if it fails — there are no user-serviceable parts.
The 1066MHz speed and CL7 latency set the throughput ceiling; under continuous heavy load the memory bus saturates before voltage or thermal limits become an issue.
Juga di rak ini
Rak yang sama, checkout yang sama — lapan koin kripto dan kunci kadar 30 minit.
Apa yang anda hantar untuk membayar, dan mata wang yang anda guna untuk membaca harga.
Dihantar daripada dompet anda semasa semak keluar
Untuk paparan sahaja — katalog diberi harga dalam USD
Tiada mata wang yang sepadan.
Pilih bahasa yang digunakan oleh laman web ini.
Tiada bahasa yang sepadan.
Pengguna baharu?
Sudah mempunyai akaun?
Tiada set semula automatik: kedai ini tidak menghantar sebarang e-mel, jadi tiada pautan sekali guna untuk diminta. Biarkan alamat pada akaun tersebut, ia akan diuruskan secara manual.
Permintaan direkodkan
Tiada apa-apa akan sampai ke peti masuk anda — kedai ini tidak menghantar sebarang e-mel. Seseorang akan menguruskannya secara manual.
Sudah teringat?