BFKK
BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
214,99 USD
0.00278135BTC
În stoc
NEMIX RAM
NEMIX RAM 8GB DDR3 1066MHz PC3-8500 CL7 1.5V 204-Pin SODIMM Laptop RAM
An 8 GB DDR3 SODIMM running at 1066 MHz with CL7 latency and 1.5 V for laptop upgrades
- Capacity8GB
- Type204-Pin DDR3 SO-DIMM
- SpeedDDR3 1066 (PC3 8500)
- CAS LatencyCL7
- Voltage1.50V
- ECCNo
- 8 GB capacity expands multitasking headroom for everyday workloads
- DDR3 1066 MHz speed matches PC3-8500 system requirements
- CL7 latency tightens response times in supported laptops
- 204-pin SODIMM form factor fits standard notebook slots
- 5 V operation aligns with DDR3 voltage specification
NEMIX 8GB DDR3 SODIMM for laptops
This 8GB module uses 204-pin DDR3 technology running at 1066MHz with a CL7 latency. It targets laptops, all-in-one PCs, small-form-factor systems and NAS devices that accept PC3-8500 unbuffered non-ECC memory. The single-stick design leaves other slots free for future expansion.
Standard voltage and no heat spreader
Operating at 1.50V, the module draws typical DDR3 power without a heat spreader, relying on the system's existing airflow. Unbuffered non-ECC construction keeps electrical load low for the memory controller. Acoustic profile is silent because there are no moving parts on the stick itself.
8GB capacity in a single 2Rx8 rank
The 8GB density is delivered through a 2Rx8 organisation, which determines compatibility with the memory controller's rank limits. Systems that only support single-rank modules or that cap total memory below 8GB per slot cannot use this stick. Verify the platform's maximum rank and per-slot capacity before purchase.
Puncte forte
- 8 GB capacity expands multitasking headroom for everyday workloads
- DDR3 1066 MHz speed matches PC3-8500 system requirements
- CL7 latency tightens response times in supported laptops
- 204-pin SODIMM form factor fits standard notebook slots
- 5 V operation aligns with DDR3 voltage specification
Specificații
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM DDR3 Orignial Series 204-Pin NON-ECC Unbuffered SODIMM Memory |
| Model | DDR3 NON- ECC Unbuffered SODIMM Laptop, AIO, SFF, NAS Storage Device Memory |
| Part Number | MS8500-828K1 |
| Capacity | 8GB |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3 1066 (PC3 8500) |
| CAS Latency | CL7 |
| Voltage | 1.50V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Heat Spreader | No |
| Features | DDR3 Laptop, AIO All-in-One, SFF, NAS Device Compatible |
Întrebări despre acest articol
How do I install this 204-pin DDR3 SODIMM in my laptop?
Power off the laptop, remove the battery if possible, open the memory compartment, align the notch on the module with the slot key, insert at an angle then press down until the clips click. The step people miss is fully seating both clips before closing the case.
What maintenance or replacement will this 8GB DDR3 1066MHz module need later?
No scheduled maintenance is required; the module has no heat spreader and runs at 1.5V. If a memory error appears, run a diagnostic and replace the stick if it fails — there are no user-serviceable parts.
What limit shows up first under sustained use with this CL7 1.50V DDR3 SODIMM?
The 1066MHz speed and CL7 latency set the throughput ceiling; under continuous heavy load the memory bus saturates before voltage or thermal limits become an issue.
Tot din acest raion
Clienții au comparat și acestea.
Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.
