Acceptăm criptomonede — astfel, criptomonedele pe care le dețineți pot cumpăra echipamente reale.Plătiți în cripto, cheltuiți-o pe echipamente reale. Livrare asigurată gratuită oriunde în lume peste 399 $. Cartoane neutre, fără marcă, expediate din Germania.Livrare asigurată gratuită peste 399 $. Cursul dumneavoastră este blocat timp de 30 de minute de la deschiderea paginii de plată.Curs blocat 30 de minute. Fiecare articol este sigilat, numărul de serie este verificat, iar produsul este acoperit de o garanție de 24 de luni.Sigilat, garantat 24 de luni.

Produse urmărite Conectare
Two green SO-DIMM sticks with black chips, no heat spreader

Computer Memory Solutions

Computer Memory Solutions CM5126410600SODRH 8GB (2x4GB) DDR3 1333MHz CL7 1.5V SO-DIMM memory upgrade

SKU CH-TQM6-E736T

8 GB kit of two 4 GB DDR3 SO-DIMM modules at 1333 MHz CL7 for Asus All-in-One PCs

  • Capacity8GB (2 x 4GB)
  • Type204-Pin DDR3 SO-DIMM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL7
  • Timing7-7-7
  • Voltage1.5V
  • 8GB dual-channel kit boosts multitasking headroom
  • CL7 1333MHz timing delivers snappy system response
  • 5V standard voltage ensures broad laptop compatibility
  • 204-pin SO-DIMM form factor fits slim all-in-one chassis
  • Guaranteed compatible with Asus ET2411IUTI and ET2410IUTS

Targeted DDR3 SO-DIMM kit

This 8 GB kit contains two 4 GB unbuffered non-ECC modules built to the DDR3 1333 (PC3 10600) standard with CL7 7-7-7 timings at 1.5 V. It is engineered specifically for Asus and Asmobile All-in-One PCs ET2411IUTI and ET2410IUTS.

Replaces factory 2 GB or 4 GB sticks

The board accepts a maximum of 8 GB across two sockets at 4 GB per slot so this kit fills both channels to the platform ceiling. The jump is worthwhile when the system currently runs with a single module or less than the 8 GB limit and a 64-bit operating system is installed.

Fits the All-in-One SO-DIMM slots directly

Each stick uses the standard 204-pin SO-DIMM form factor without a heat spreader so it slides into the existing slots inside the ET2411 or ET2410 chassis. No extra power connectors or cooling clearance are required and the dual-rank 2Rx8 organisation works with the native memory controller.

Puncte forte

  • 8GB dual-channel kit boosts multitasking headroom
  • CL7 1333MHz timing delivers snappy system response
  • 5V standard voltage ensures broad laptop compatibility
  • 204-pin SO-DIMM form factor fits slim all-in-one chassis
  • Guaranteed compatible with Asus ET2411IUTI and ET2410IUTS

Specificații

BrandComputer Memory Solutions
ModelCM5126410600SODRH
Capacity8GB (2 x 4GB)
Type204-Pin DDR3 SO-DIMM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL7
Timing7-7-7
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemAsus/Asmobile All In One Pc Et2411Iuti, Et2410Iuts
Package Content2 Memory RAM Sticks

Întrebări despre acest articol

Does this 204-pin SO-DIMM kit fit the two memory slots inside the Asus ET2411IUTI all-in-one?

Yes, the kit is built for the ET2411IUTI and ET2410IUTS chassis, which each have two SO-DIMM sockets accepting up to 4 GB per slot for a total of 8 GB.

What is the correct way to seat both 4 GB modules so the system sees the full 8 GB?

Power off, open the memory door, insert each stick at the same angle until the gold contacts disappear, then press down firmly until both side clips click — skipping the second click leaves the module loose and the capacity unrecognised.

When should I expect to replace these DDR3 modules in the ET2410IUTS?

DDR3 SO-DIMMs have no moving parts and typically last the life of the all-in-one; swap them only if a memory test reports errors or you upgrade the platform beyond DDR3.

Tot din acest raion

Clienții au comparat și acestea.

Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.