Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Two green SO-DIMM sticks with black chips, no heat spreader

Computer Memory Solutions

Computer Memory Solutions CM5126410600SODRH 8GB (2x4GB) DDR3 1333MHz CL7 1.5V SO-DIMM memory upgrade

SKU CH-TQM6-E736T

8 GB kit of two 4 GB DDR3 SO-DIMM modules at 1333 MHz CL7 for Asus All-in-One PCs

  • Capacity8GB (2 x 4GB)
  • Type204-Pin DDR3 SO-DIMM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL7
  • Timing7-7-7
  • Voltage1.5V
  • 8GB dual-channel kit boosts multitasking headroom
  • CL7 1333MHz timing delivers snappy system response
  • 5V standard voltage ensures broad laptop compatibility
  • 204-pin SO-DIMM form factor fits slim all-in-one chassis
  • Guaranteed compatible with Asus ET2411IUTI and ET2410IUTS

Targeted DDR3 SO-DIMM kit

This 8 GB kit contains two 4 GB unbuffered non-ECC modules built to the DDR3 1333 (PC3 10600) standard with CL7 7-7-7 timings at 1.5 V. It is engineered specifically for Asus and Asmobile All-in-One PCs ET2411IUTI and ET2410IUTS.

Replaces factory 2 GB or 4 GB sticks

The board accepts a maximum of 8 GB across two sockets at 4 GB per slot so this kit fills both channels to the platform ceiling. The jump is worthwhile when the system currently runs with a single module or less than the 8 GB limit and a 64-bit operating system is installed.

Fits the All-in-One SO-DIMM slots directly

Each stick uses the standard 204-pin SO-DIMM form factor without a heat spreader so it slides into the existing slots inside the ET2411 or ET2410 chassis. No extra power connectors or cooling clearance are required and the dual-rank 2Rx8 organisation works with the native memory controller.

Přednosti

  • 8GB dual-channel kit boosts multitasking headroom
  • CL7 1333MHz timing delivers snappy system response
  • 5V standard voltage ensures broad laptop compatibility
  • 204-pin SO-DIMM form factor fits slim all-in-one chassis
  • Guaranteed compatible with Asus ET2411IUTI and ET2410IUTS

Specifikace

BrandComputer Memory Solutions
ModelCM5126410600SODRH
Capacity8GB (2 x 4GB)
Type204-Pin DDR3 SO-DIMM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL7
Timing7-7-7
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemAsus/Asmobile All In One Pc Et2411Iuti, Et2410Iuts
Package Content2 Memory RAM Sticks

Otázky k tomuto produktu

Does this 204-pin SO-DIMM kit fit the two memory slots inside the Asus ET2411IUTI all-in-one?

Yes, the kit is built for the ET2411IUTI and ET2410IUTS chassis, which each have two SO-DIMM sockets accepting up to 4 GB per slot for a total of 8 GB.

What is the correct way to seat both 4 GB modules so the system sees the full 8 GB?

Power off, open the memory door, insert each stick at the same angle until the gold contacts disappear, then press down firmly until both side clips click — skipping the second click leaves the module loose and the capacity unrecognised.

When should I expect to replace these DDR3 modules in the ET2410IUTS?

DDR3 SO-DIMMs have no moving parts and typically last the life of the all-in-one; swap them only if a memory test reports errors or you upgrade the platform beyond DDR3.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.