NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Acceptăm criptomonede — astfel, criptomonedele pe care le dețineți pot cumpăra echipamente reale.Plătiți în cripto, cheltuiți-o pe echipamente reale. Livrare asigurată gratuită oriunde în lume peste 399 $. Cartoane neutre, fără marcă, expediate din Germania.Livrare asigurată gratuită peste 399 $. Cursul dumneavoastră este blocat timp de 30 de minute de la deschiderea paginii de plată.Curs blocat 30 de minute. Fiecare articol este sigilat, numărul de serie este verificat, iar produsul este acoperit de o garanție de 24 de luni.Sigilat, garantat 24 de luni.
myVolts
A 50cm sleeved PSU cable extension kit with 1x24-pin, 2xCPU and 3xGPU connectors using 18AWG UL 1015 tinned copper wire and cable combs
This kit bundles a 24-pin ATX extension, two 4+4-pin CPU extensions and three 6+2-pin GPU extensions in one package. The 500 mm length suits full-tower and mid-tower builds that need extra reach for clean routing. Enthusiasts who want a single colour scheme across every power lead will find the OrangeBlack finish ready to match.
Each lead uses 18 AWG UL 1015 tinned copper conductors inside a high-density braided sleeve that resists heat and humidity. The sleeve stays flexible enough to train around tight corners without kinking. Fifteen 8-pin combs and three 24-pin combs are included to lock cables into parallel runs for a professional finish.
The thicker 18 AWG gauge reduces voltage drop across the 50 cm extension compared with thinner alternatives. Tinned copper strands resist oxidation so contact resistance stays low over time. No active components are added, so the kit draws no extra power and adds no audible noise to the system.
| Type | AT |
|---|
The 24-pin extension uses the standard ATX pin-out and adds 50 cm to the existing cable run, staying within typical routing limits for full-tower cases.
The high-density braid on 18 AWG UL 1015 wire adds roughly 3 mm of diameter, so allow at least 20 mm behind the tray and use the supplied 24-pin and 8-pin combs to lock spacing.
Route each extension from the component back to the PSU, seat the factory connectors first, then snap the combs on 2 cm intervals; the step most builders miss is tightening combs before the final bend.
Tot din acest raion
Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.
În ce monedă plătiți și în ce monedă citiți prețurile.
Trimis din portofelul dumneavoastră la finalizarea comenzii
Doar pentru afișare — catalogul este exprimat în dolari
Nicio monedă nu corespunde.
Alegeți limba în care vă vorbește site-ul.
Prima vizită?
Aveți deja un cont?
Nu există o resetare automată: acest magazin nu trimite niciun e-mail, deci nu există niciun link de unică folosință de solicitat. Lăsați adresa în cont. Va fi tratată manual.
Cerere înregistrată
Nu veți primi nimic în căsuța de e-mail — acest magazin nu trimite niciun e-mail. Cineva se ocupă de asta manual.
V-ați amintit-o?