We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Orange and black braided PSU cable extension kit with 24-pin, two CPU and three GPU connectors, plus cable combs

myVolts

myVolts 50cm PSU Cable Extension Kit OrangeBlack 2xCPU 3xGPU 24Pin 18AWG

SKU CH-3WP9-TZC7B

A 50cm sleeved PSU cable extension kit with 1x24-pin, 2xCPU and 3xGPU connectors using 18AWG UL 1015 tinned copper wire and cable combs

  • TypeAT
  • Complete PSU extension kit with 2 CPU, 3 GPU and 24-pin cables
  • 18AWG UL 1015 tinned copper wires for heat and humidity resistance
  • High-density braided sleeves with 18 included cable combs for clean routing
  • 50 cm length in OrangeBlack, one of 17 colour options
  • Flexible design trains easily to custom curves without pre-shaping

Build your look

This kit bundles a 24-pin ATX extension, two 4+4-pin CPU extensions and three 6+2-pin GPU extensions in one package. The 500 mm length suits full-tower and mid-tower builds that need extra reach for clean routing. Enthusiasts who want a single colour scheme across every power lead will find the OrangeBlack finish ready to match.

Wire and combs

Each lead uses 18 AWG UL 1015 tinned copper conductors inside a high-density braided sleeve that resists heat and humidity. The sleeve stays flexible enough to train around tight corners without kinking. Fifteen 8-pin combs and three 24-pin combs are included to lock cables into parallel runs for a professional finish.

Signal integrity

The thicker 18 AWG gauge reduces voltage drop across the 50 cm extension compared with thinner alternatives. Tinned copper strands resist oxidation so contact resistance stays low over time. No active components are added, so the kit draws no extra power and adds no audible noise to the system.

Highlights

  • Complete PSU extension kit with 2 CPU, 3 GPU and 24-pin cables
  • 18AWG UL 1015 tinned copper wires for heat and humidity resistance
  • High-density braided sleeves with 18 included cable combs for clean routing
  • 50 cm length in OrangeBlack, one of 17 colour options
  • Flexible design trains easily to custom curves without pre-shaping

Specifications

TypeAT

Questions about this item

Does the 24-pin ATX extension follow the standard ATX pin-out and length limit?

The 24-pin extension uses the standard ATX pin-out and adds 50 cm to the existing cable run, staying within typical routing limits for full-tower cases.

What clearance and comb spacing do the 18 AWG sleeved cables need behind the motherboard tray?

The high-density braid on 18 AWG UL 1015 wire adds roughly 3 mm of diameter, so allow at least 20 mm behind the tray and use the supplied 24-pin and 8-pin combs to lock spacing.

How do I install the extensions without kinking the braid at the PSU-side connectors?

Route each extension from the component back to the PSU, seat the factory connectors first, then snap the combs on 2 cm intervals; the step most builders miss is tightening combs before the final bend.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.