Acceptăm criptomonede — astfel, criptomonedele pe care le dețineți pot cumpăra echipamente reale.Plătiți în cripto, cheltuiți-o pe echipamente reale. Livrare asigurată gratuită oriunde în lume peste 399 $. Cartoane neutre, fără marcă, expediate din Germania.Livrare asigurată gratuită peste 399 $. Cursul dumneavoastră este blocat timp de 30 de minute de la deschiderea paginii de plată.Curs blocat 30 de minute. Fiecare articol este sigilat, numărul de serie este verificat, iar produsul este acoperit de o garanție de 24 de luni.Sigilat, garantat 24 de luni.

Produse urmărite Conectare
Two green DDR5 UDIMM sticks without heat spreaders, 288-pin, 64GB kit

NEMIX RAM

NEMIX RAM 64GB (2x32GB) DDR5 4800 CL40 1.1V UDIMM memory upgrade

SKU CH-WH0W-VTRSE

A 64 GB dual-channel DDR5 kit running at 4800 MT/s with CL40 latency and 1.1 V operation for ASRock Z790 and B650 motherboards

  • Capacity64GB (2 x 32GB)
  • SpeedDDR5 4800 (PC5 38400)
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.10V
  • 64GB total capacity across two 32GB modules for high-density desktop upgrades
  • DDR5 4800 speed rated at PC5-38400 for fast data throughput
  • CL40 CAS latency at 1.1V standard voltage for efficient operation
  • 288-pin UDIMM form factor with 2Rx8 rank organisation for broad motherboard compatibility
  • Tested compatible with ASRock Z790 and B650 LiveMixer motherboards

Targeted DDR5 kit for ASRock Z790

This 64 GB kit contains two 32 GB unbuffered UDIMMs rated at DDR5 4800 with CL40 timings. It is built for desktop PCs that use the specified ASRock motherboards and need a straight-forward capacity increase. No heat spreaders are included, keeping the modules low-profile for tight CPU cooler clearances.

Standard 288-pin DDR5 UDIMM form factor

Each module uses a 2Rx8 organisation and runs at the JEDEC 1.10 V baseline, so no manual voltage tuning is required. The plain green PCB fits any desktop slot wired for DDR5, and the dual-rank layout helps fill four-channel controllers efficiently. Installation follows the usual UDIMM procedure described in the motherboard manual.

Two-module kit validated for the listed ASRock

The package delivers exactly the 64 GB (2 x 32 GB) configuration tested for compatibility with the Z790 LiveMixer and B650 LiveMixer broadcasting motherboards. Buyers who need ECC error correction, registered signalling, or speeds above the 4800 MT/s JEDEC base should look for a different module type.

Puncte forte

  • 64GB total capacity across two 32GB modules for high-density desktop upgrades
  • DDR5 4800 speed rated at PC5-38400 for fast data throughput
  • CL40 CAS latency at 1.1V standard voltage for efficient operation
  • 288-pin UDIMM form factor with 2Rx8 rank organisation for broad motherboard compatibility
  • Tested compatible with ASRock Z790 and B650 LiveMixer motherboards

Specificații

BrandNEMIX RAM
SeriesASRock Gaming Motherboard Compatible Series Memory
ModelASRock DDR5 4800MHZ Non-ECC Unbuffered UDIMM
Part NumberMD38400-328K2
Capacity64GB (2 x 32GB)
SpeedDDR5 4800 (PC5 38400)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.10V
Compatible SystemASRock
CAS LatencyCL40
Heat SpreaderNo
Type288-Pin DDR5 UDIMM
Rank2Rx8
FeaturesDDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content64GB (2X32GB) DDR5 4800MHZ PC5-38400 2Rx8 1.1V CL40 288-PIN Non-ECC Unbuffered UDIMM KIT

Întrebări despre acest articol

What DDR5 speed does this 64 GB kit run at, and what does the PC5-38400 rating mean for bandwidth?

The kit is rated DDR5 4800 (PC5-38400), so the standard's peak transfer rate is 38400 MB/s; actual throughput depends on the motherboard's memory controller and BIOS settings.

Will these 288-pin UDIMMs fit in the four DIMM slots on my ASRock Z790 or B650 LiveMixer board?

Yes, each module is a standard 288-pin DDR5 UDIMM and the kit contains two 32 GB sticks, so they install directly into any DDR5 desktop DIMM slot on those motherboards.

Do I need to enable XMP or EXPO in the BIOS to reach the rated CL40 4800 speed, or will it run at that speed automatically?

DDR5 defaults to 4800 MT/s at 1.1 V without any profile; the modules will run at CL40 4800 automatically, though you can still enable an XMP/EXPO profile if your board offers one for tighter timings.

Tot din acest raion

Clienții au comparat și acestea.

Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.