Tripp Lite
Tripp Lite PDUMNH15 Monitored 1U PDU 120V 15A 8x 5-15R
- Monitored
- 1U
328,99 USD
0.00422015BTC
În stoc
OEM Industries
OEM Industries MGT8012HB-A25 80mm 25mm 12V 0.24A 3-pin CPU cooler
80 mm square fan with ball bearing, 12 V 0.24 A three-pin power for server CPU cooling
- ColorBlack
- TypeFan only
- Fan Size80mm
- Bearing TypeBall
- Power Connector3 Pin
- LEDNo
- 80 mm fan fits tight server and case spaces
- 25 mm thickness balances airflow and clearance
- Ball bearing design extends operating life
- 12 V 0.24 A draw keeps power use low
- Three pin connector enables speed monitoring
Compact 80 mm server fan
The OEM Industries MGT8012HB-A25 is an 80 mm square fan built for 12 V server and workstation chassis. It draws 0.24 A through a standard three-pin connector and uses a ball bearing for continuous operation. The black frame fits tight 80 mm mounts in rack-mount or small-form-factor systems.
Replaces worn 80 mm ball-bearing units
Swap this fan in when an existing 80 mm cooler becomes noisy, vibrates or fails to spin at full speed. The 12 V 0.24 A rating matches many legacy server trays, so the upgrade is worthwhile when the original sleeve-bearing fan has seized or the airflow has dropped below specification.
Direct three-pin drop-in
Installation requires aligning the four mounting holes and pressing the three-pin plug onto the motherboard or backplane header. The only common issue is reversed polarity if the keyed connector is forced the wrong way; otherwise the fan seats flush in standard 80 mm cut-outs.
Puncte forte
- 80 mm fan fits tight server and case spaces
- 25 mm thickness balances airflow and clearance
- Ball bearing design extends operating life
- 12 V 0.24 A draw keeps power use low
- Three pin connector enables speed monitoring
Specificații
| Model | MGT8012HB-A25 |
|---|---|
| Color | Black |
| Type | Fan only |
| Fan Size | 80mm |
| Bearing Type | Ball |
| Power Connector | 3 Pin |
| LED | No |
Întrebări despre acest articol
What mounting holes does the 80mm square frame use?
The fan uses the standard 80mm square mounting pattern with four corner holes spaced for 80mm centres.
How do I connect the 3-pin connector so speed reporting works?
Plug the 3-pin header onto a motherboard 3-pin or 4-pin fan header aligning the key; the third wire carries the tach signal for RPM monitoring.
When should I replace the ball-bearing fan?
Replace the fan when bearing noise becomes audible or RPM drops below the rated speed under 12V 0.24A load.
Tot din acest raion
Clienții au comparat și acestea.
Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.
