Brute Networks 16GB DDR5-4800 1Rx8 ECC UDIMM

Dell-compatible 16 GB DDR5-4800 ECC UDIMM

This module is a 16 GB DDR5-4800 ECC UDIMM built to match Dell part number 1XYCY. It targets system administrators and integrators who need guaranteed compatibility when expanding or repairing supported Dell servers. The unbuffered design with on-die ECC suits platforms that accept UDIMM memory. Each unit ships new and carries a lifetime warranty from the supplier.

DDR5-4800 speed ceiling and UDIMM slot constraint

The PC5-38400 rating sets a hard data-rate ceiling of 4800 MT/s; the memory controller cannot push this module beyond that frequency. Because it is an unbuffered DIMM, it only fits motherboards wired for UDIMM slots and will not seat in registered or load-reduced DIMM sockets. Mixing with faster or slower DDR5 modules forces the entire channel to run at the lowest common speed, so uniform population is required for rated performance.

16 GB capacity per module with single-rank headroom

A single 16 GB rank provides enough space for typical virtualization hosts, database buffers and container workloads on supported platforms. The single-rank 1Rx8 organisation helps keep electrical loading low, allowing higher total module counts per channel where the motherboard permits. Workloads that exceed 16 GB per thread or require multi-terabyte footprints will need additional DIMM slots or higher-density modules not covered by this part.