SanDisk
SanDisk Cruzer Blade 8 GB USB 2.0 USB flash drive Black SDCZ50-008G-B35
391,99 USD
0.00501343BTC
Skladom
Computer Memory Solutions
Computer Memory Solutions 4GB (2x2GB) DDR2 800MHz PC2-6400 CL6 1.8V Non-ECC DIMM Dell Precision 390
A 4 GB dual-channel DDR2 kit rated at 800 MHz with CL6 timings, validated for the Dell Precision 390
- Capacity4GB (2 x 2GB)
- Type240-Pin DDR2 SDRAM
- SpeedDDR2 800 (PC2 6400)
- CAS LatencyCL6
- Timing6-6-6
- Voltage1.8V
- Guaranteed compatibility with Dell Precision 390 workstations
- 4 GB total capacity in a matched 2 × 2 GB kit
- DDR2-800 (PC2-6400) speed for responsive performance
- Low CL6 latency with 1.8 V operation
- Unbuffered non-ECC 240-pin DIMMs ready to install
Dell Precision 390 upgrade kit
This 4 GB kit contains two 2 GB DDR2 modules rated at 800 MHz with CL6 timings and 1.8 V operation. The unbuffered, non-ECC DIMMs use a 240-pin layout and are built with major-brand chipsets. Computer Memory Solutions validates the kit specifically for the Dell Precision Workstation 390.
Owners of a Precision 390 needing a matched pair
The kit suits users restoring or expanding a Precision 390 that accepts DDR2 memory. Systems that require ECC, registered modules, a different pin count, or a later memory generation will not accept these sticks. Buyers with other Dell workstations should verify their exact model before purchasing.
DDR2 800 MHz CL6 specification
The modules run at PC2-6400 speed with 6-6-6 timing at 1.8 V. This electrical and timing profile is the single factor that determines whether the kit will post and run stably in the Precision 390. Any deviation in speed, voltage or latency means the memory is not the correct part for this workstation.
Prednosti
- Guaranteed compatibility with Dell Precision 390 workstations
- 4 GB total capacity in a matched 2 × 2 GB kit
- DDR2-800 (PC2-6400) speed for responsive performance
- Low CL6 latency with 1.8 V operation
- Unbuffered non-ECC 240-pin DIMMs ready to install
Špecifikácie
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM256646400DIMMDR |
| Capacity | 4GB (2 x 2GB) |
| Type | 240-Pin DDR2 SDRAM |
| Speed | DDR2 800 (PC2 6400) |
| CAS Latency | CL6 |
| Timing | 6-6-6 |
| Voltage | 1.8V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Dell Precision Workstation 390 |
| Package Content | 2 Memory RAM Sticks |
Otázky k tomuto produktu
What DDR2 standard and speed does this 240-pin kit run at?
The modules are rated PC2-6400 at 800 MHz with CL6 timing and operate at 1.8 V.
Will the two 2 GB sticks fit the four DIMM slots in my Precision 390?
Yes, each stick is a standard 240-pin unbuffered DIMM and the system has four slots supporting up to 8 GB total.
What is the correct way to seat the pair so the board recognises the full 4 GB?
Insert both modules firmly until the retention clips click, then power on and verify 4 GB in BIOS; the common mistake is leaving one clip unlatched.
Aj v tomto oddelení
Zákazníci tiež porovnávali
Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.
