Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.

Sledované položky Prihlásiť sa
Two green DDR4 DIMM sticks, no heat spreaders, 288 pins each

Computer Memory Solutions

Computer Memory Solutions CM512642400DIMM 8GB (2x4GB) DDR4 2400 CL17 Prodesk 490 600 G2 G3 memory upgrade

SKU CH-2WDC-Y12KZ

8 GB DDR4 kit (2 × 4 GB) at 2400 MHz CL17 for HP ProDesk 490 G3 and 600 G2/G3 SFF/MT

  • Capacity8GB (2 x 4GB)
  • Type288-Pin DDR4 SDRAM
  • SpeedDDR4 2400 (PC4 19200)
  • CAS LatencyCL17
  • Timing17-17-17
  • Voltage1.2V
  • Ready for HP ProDesk 490 G3 MT and 600 G2/G3 SFF or MT
  • 8 GB dual-channel kit (2 × 4 GB) for smoother multitasking
  • DDR4 2400 MHz CL17 at 1.2 V for stable speed
  • Non-ECC unbuffered 288-pin DIMMs install without tools
  • Manufacturer lifetime exchange warranty against defects

HP Prodesk 490 G3 and 600 G2/G3 upgrade

This 8 GB kit contains two 4 GB DDR4 modules rated at 2400 MHz with CL17 timings. It is built for the HP Prodesk 490 G3 MT and 600 G2 and G3 series in both small-form-factor and mini-tower chassis. The unbuffered non-ECC DIMMs suit office workstations that need a straightforward capacity increase.

Sustained-load behaviour

Operating at 1.2 V, the modules run within standard DDR4 voltage limits during extended sessions. CL17 latency at 2400 MHz delivers consistent throughput for typical business workloads such as document handling, browser tabs and light multitasking. The dual-rank 2Rx8 organisation helps maintain bandwidth when all four slots are populated.

Build and connectors

Each stick uses a standard 288-pin DIMM edge connector with no heat spreader, keeping the profile low for tight SFF cases. Major-brand DRAM chips are used to reduce compatibility issues on the qualified Prodesk platforms. The two-module kit allows population of paired slots for dual-channel operation on boards with four sockets.

Prednosti

  • Ready for HP ProDesk 490 G3 MT and 600 G2/G3 SFF or MT
  • 8 GB dual-channel kit (2 × 4 GB) for smoother multitasking
  • DDR4 2400 MHz CL17 at 1.2 V for stable speed
  • Non-ECC unbuffered 288-pin DIMMs install without tools
  • Manufacturer lifetime exchange warranty against defects

Špecifikácie

BrandComputer Memory Solutions
ModelCM512642400DIMM
Capacity8GB (2 x 4GB)
Type288-Pin DDR4 SDRAM
SpeedDDR4 2400 (PC4 19200)
CAS LatencyCL17
Timing17-17-17
Voltage1.2V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemHP/Compaq Prodesk 490 G3 MT, 600 G2 Series SFF/MT, 600 G3 Series MT/SFF
Package Content2 Memory RAM Sticks

Otázky k tomuto produktu

How much power does the 1.2 V DDR4 kit draw when the ProDesk 600 G3 runs all day?

The modules operate at the standard DDR4 voltage of 1.2 V, keeping power draw and heat low during continuous use in your ProDesk 600 G3.

Does the HP ProDesk 490 G3 MT need any extra parts or tools to install these 288-pin DIMMs?

No extra parts are required; the 288-pin DDR4 DIMMs slot directly into the four memory sockets of the ProDesk 490 G3 MT.

Will the CL17 DDR4-2400 modules run correctly alongside the factory memory in a 600 G2 MT?

Yes, the CL17 DDR4-2400 kit is validated for the 600 G2 MT and will operate at the system's supported speed when mixed with existing modules.

Aj v tomto oddelení

Zákazníci tiež porovnávali

Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.