Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.

Sledované položky Prihlásiť sa
Black standalone CFast duplicator with one source slot and seven target slots, 16x2 LCD panel

EZ Dupe, Inc.

EZ Dupe, Inc. CFAST01TB150 1-to-7 CFast duplicator

SKU CH-QB1E-J9REC

Standalone CFast duplicator copies one source card to seven targets at 150 MB/s with four copy modes, four erase modes including DoD 5220.22-M, and a 16×2 LCD

  • Panel ColorBlack
  • Operating TypeStandalone
  • Data Source ROM1 CFAST Slot for Source Reading
  • Data Destination Burner7 CFAST Slots for CFAST to CFAST Copy
  • Display16 x 2 LCD
  • ConnectorCFAST

Target 1 to 7

  • Standalone operation — no PC or software required
  • 1-to-7 CFast duplication at 150 MB/s per slot
  • Four copy modes including quick, full, partition and percentage
  • Four erase modes with DoD 3-pass and 7-pass 5220.22 compliance
  • 16 × 2 LCD with four-key panel for local control

What it is

The EZ Dupe CFAST01TB150 is a standalone duplicator that copies one source CompactFAST card to seven target cards at once. It is built for production teams, forensic labs and IT departments that need fast, verified clones without tying up a host computer.

The deciding spec

Copy speed reaches 150MB/s per slot, so a full 9GB transfer finishes in roughly one minute per card. If your workflow demands higher throughput per slot, this unit will not meet that requirement.

Installation and pitfalls

Plug the unit into 115–230 V AC power, insert the source card into the single read slot and up to seven targets into the write slots, then choose a copy or erase mode on the 16×2 LCD. The most common mistake is mixing card capacities or file-system types, which causes the compare check to fail and forces a restart of the job.

Prednosti

  • Standalone operation — no PC or software required
  • 1-to-7 CFast duplication at 150 MB/s per slot
  • Four copy modes including quick, full, partition and percentage
  • Four erase modes with DoD 3-pass and 7-pass 5220.22 compliance
  • 16 × 2 LCD with four-key panel for local control

Špecifikácie

BrandEZ Dupe
ModelCFAST01TB150
Part NumberCFAST01TB150
Panel ColorBlack
Operating TypeStandalone
Data Source ROM1 CFAST Slot for Source Reading
Data Destination Burner7 CFAST Slots for CFAST to CFAST Copy
Display16 x 2 LCD
ConnectorCFAST
Target1 to 7
Buffer Memory128M
ControllerAthena Controller
Supported MediaCompactFAST (CFAST)
Data Transfer Rate150MB/s
Load TypeSlot
Key FeaturesStandalone
FeaturesDuplication
Power SupplyAC: 115-230 V, 50/60 Hz

Ďalšie verzie tohto modelu

Ďalších 3 v tomto rade

Rovnaký rad, iná pamäť, chladič alebo frekvencia — porovnajte pred rozhodnutím.

Otázky k tomuto produktu

What does 150 MB/s copy speed mean when I am duplicating seven cards at once?

Each of the seven destination slots sustains up to 150 MB/s independently, so all cards finish in the same time as a single copy.

Which CFast interface standard does the duplicator use and what limits its throughput?

The unit uses the CFast connector and is capped at 150 MB/s per slot by the Athena Controller.

What clearance and power do I need to install this duplicator?

It runs on 115-230 V AC at 50/60 Hz and fits in a standard rack space with front-loading CFast slots.

Aj v tomto oddelení

Zákazníci tiež porovnávali

Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.