Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.

Sledované položky Prihlásiť sa
550W 1U server power supply unit in metal case

godream

godream 550W 1U Switch Power Supply for Huntkey flex650

SKU CH-D5VZ-GVYCS

A 550W 1U ATX power supply built to replace the Huntkey flex650 unit in FLEX ITX computers or servers

  • TypeATX
  • 550W output powers compact ITX and server builds
  • 1U form factor fits slim rackmount and flex chassis
  • Designed for Huntkey flex650 compatibility
  • New ATX switch-mode unit ready for installation

550W 1U PSU for Huntkey flex650

This 550W 1U switch-mode power supply is designed as a direct replacement for the Huntkey flex650 unit. It fits FLEX ITX form-factor chassis used in compact computers and servers. The ATX-type design delivers 550 watts of continuous power for standard system components.

Replaces the original Huntkey flex650 supply

Install this unit when the original 650W flex650 power supply has failed or when a spare is required for maintenance. The 550W rating suits builds that do not demand the higher wattage of the original model. It is not for systems needing more than 550 watts or for chassis incompatible with the 1U FLEX ITX form factor.

Prednosti

  • 550W output powers compact ITX and server builds
  • 1U form factor fits slim rackmount and flex chassis
  • Designed for Huntkey flex650 compatibility
  • New ATX switch-mode unit ready for installation

Špecifikácie

TypeATX

Otázky k tomuto produktu

Will this 1U power supply fit a standard ATX chassis?

This unit follows the 1U ATX form factor, so it fits 1U server racks and ATX cases that accept 1U supplies; verify your chassis depth before buying.

What is the correct way to seat the power supply in a 1U slot?

Slide the unit fully into the bay until the rear flange contacts the chassis, then secure all mounting screws; the most common mistake is leaving a gap that prevents the rear connectors from aligning.

Aj v tomto oddelení

Zákazníci tiež porovnávali

Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.