BFKK
BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
214,99 USD
0.002786BTC
Skladom
Hynix
Hynix HMA82GU6MFR8N-TF 16 GB DDR4 2133 MHz UDIMM
16 GB DDR4 desktop UDIMM running at 2133 MHz (PC4-17000) in a 2Rx8 configuration
- 16 GB capacity for demanding desktop workloads
- DDR4-2133 speed for responsive system performance
- 2Rx8 dual-rank architecture for improved memory throughput
- PC4-17000 bus rating for reliable data transfer
- UDIMM form factor fits standard desktop motherboards
Capacity and platform fit
This 16 GB DDR4 UDIMM module runs at 2133 MHz (PC4-17000) and is built for desktop systems that accept unbuffered memory. It suits owners upgrading a single slot or adding capacity to a board with limited DIMM positions. Buyers needing ECC, registered modules or speeds above 2133 MHz should look elsewhere.
Sustained throughput behaviour
The dual-rank 2Rx8 organisation allows the memory controller to keep both ranks busy during long workloads such as video rendering or virtualisation. Bandwidth remains steady at the rated 2133 MT/s without the drops sometimes seen in single-rank sticks under continuous pressure. Latency stays consistent because the module operates at standard JEDEC timings.
Thermals noise and power
Standard DDR4 voltage keeps heat output low enough for ordinary case airflow; no active cooling is required. The bare circuit board produces no audible noise during operation. Power draw scales with actual utilisation rather than spiking, so the module adds minimal load to the system power budget.
Prednosti
- 16 GB capacity for demanding desktop workloads
- DDR4-2133 speed for responsive system performance
- 2Rx8 dual-rank architecture for improved memory throughput
- PC4-17000 bus rating for reliable data transfer
- UDIMM form factor fits standard desktop motherboards
Špecifikácie
Pre tento produkt zatiaľ nie sú zverejnené žiadne špecifikácie.
Otázky k tomuto produktu
How much power does this 16 GB DDR4-2133 UDIMM draw when the system runs all day?
DDR4 modules typically operate at 1.2 V, so a single 16 GB stick at 2133 MHz draws only a few watts under load, keeping heat output low during continuous use.
What motherboard slot and memory controller does this PC4-17000 module require to work?
It needs a standard 288-pin UDIMM slot and a DDR4 memory controller; the board must support PC4-17000 (DDR4-2133) speeds for the module to run at its rated frequency.
Can this DDR4-2133 stick share a motherboard with older DDR4 modules rated at lower speeds?
Yes, the motherboard will run all installed DDR4 modules at the speed of the slowest stick, so this PC4-17000 module will downclock to match any slower DDR4 DIMMs you keep.
Aj v tomto oddelení
Zákazníci tiež porovnávali
Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.
