Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.

Sledované položky Prihlásiť sa
Rectangular ATX power supply unit, matte metal finish, label shows 12V 30A and 12V 1.0A outputs

KHACHIMO

KHACHIMO XL375-12 CS Power Supply V1 12V 30A V2 1.0A

SKU CH-48PH-70VSZ

Delivers 12 V at 30 A plus a 1.0 A auxiliary rail in an ATX form factor

  • TypeATX
  • Delivers 12 V at 30 A for high-current loads
  • Auxiliary 12 V at 1.0 A powers standby rails
  • ATX form factor fits standard chassis
  • Tested working and built with good quality components

ATX power module for industrial builds

This KHACHIMO XL375-12 CS power supply is an ATX-form-factor module rated for 375 W total output. It delivers a primary 12 V rail at 30 A and a secondary 12 V rail at 1.0 A. The unit is supplied new and has been tested working.

375 W capacity with dual 12 V rails

The 30 A main rail handles demanding 12 V loads such as GPU arrays or dense storage backplanes, while the 1.0 A auxiliary rail supports standby or management circuits. Builds requiring more than 375 W combined draw or additional voltage rails will need a higher-capacity or multi-rail solution.

Prednosti

  • Delivers 12 V at 30 A for high-current loads
  • Auxiliary 12 V at 1.0 A powers standby rails
  • ATX form factor fits standard chassis
  • Tested working and built with good quality components

Špecifikácie

TypeATX

Otázky k tomuto produktu

Will the V1 12 V 30 A rail power my existing ATX motherboard and drives without adapters?

The module follows the ATX form factor and delivers 12 V at 30 A on the V1 rail, matching standard ATX 12 V requirements for motherboards and drives.

How can I verify the V2 12 V 1.0 A auxiliary output is live after installation?

Measure 12 V on the V2 pins with a multimeter while the unit is powered on; a reading near 12 V confirms the auxiliary rail is operating.

Aj v tomto oddelení

Zákazníci tiež porovnávali

Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.