Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.

Sledované položky Prihlásiť sa
Green circuit board with black memory chips and gold edge connector

NEMIX RAM

NEMIX RAM 16GB DDR4 3200 ECC Unbuffered UDIMM CL22 1.2V 2Rx8 memory upgrade

SKU CH-BQ46-VCM9J

16 GB DDR4 3200 ECC unbuffered UDIMM with CL22 latency and 1.2 V operation for Supermicro servers

  • Capacity16GB
  • SpeedDDR4 3200 (PC4 25600)
  • ECCYes
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • ECC protection guards data integrity in critical workloads
  • 3200 MHz DDR4 speed supports responsive server performance
  • 2 V operation reduces power draw and heat
  • 2Rx8 dual-rank layout enables higher density per slot
  • Validated for Supermicro R12SPD-A compatibility

Compatible Supermicro Server Upgrade

This NEMIX RAM module adds 16GB of DDR4 3200 ECC unbuffered memory to compatible Supermicro systems. It runs at 1.2V with CL22 latency and uses a 2Rx8 organisation on a 288-pin UDIMM. The kit contains a single stick built with major OEM chips from Samsung, Micron or Hynix.

Replaces Slower Non-ECC Modules

The upgrade makes sense when a Supermicro workstation or server needs error-correcting memory at 3200 speed instead of standard unbuffered RAM. It is not for platforms that require registered DIMMs or for builds that cannot use ECC unbuffered UDIMMs at this voltage and rank configuration.

Simple DIMM Installation

The module seats in a standard DDR4 UDIMM slot without extra cables or tools. Common issues arise when mixing ranks or speeds across channels, or when the BIOS is not updated to recognise 2Rx8 density at 3200 MT/s. Always verify the motherboard qualified-vendor list before fitting.

Prednosti

  • ECC protection guards data integrity in critical workloads
  • 3200 MHz DDR4 speed supports responsive server performance
  • 2 V operation reduces power draw and heat
  • 2Rx8 dual-rank layout enables higher density per slot
  • Validated for Supermicro R12SPD-A compatibility

Špecifikácie

BrandNEMIX RAM
SeriesSuperMicro Server/Workstation Compatible Series Memory
ModelSuperMicro DDR4 3200MHZ ECC Unbuffered UDIMM
Part NumberME25600-628K1
Capacity16GB
SpeedDDR4 3200 (PC4 25600)
ECCYes
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemSupermicro
CAS LatencyCL22
Heat SpreaderNo
Type288-Pin DDR4 ECC UDIMM
Rank2Rx8
FeaturesDDR4 ECC Unbuffered UDIMM Motherboard Compatible
Package Content16GB (1X16GB) DDR4 3200MHZ PC4-25600 2Rx8 1.2V CL22 288-PIN ECC Unbuffered UDIMM

Otázky k tomuto produktu

Does this 288‑pin DDR4 UDIMM fit a standard server DIMM slot?

Yes, the module uses the standard 288‑pin DDR4 UDIMM form factor, so it seats in any compatible server or workstation slot that accepts unbuffered ECC memory.

What is the correct way to seat the module so the ECC function works?

Align the notch with the slot key, press straight down until both side latches click, then verify in BIOS that ECC is enabled and the system reports 16 GB at 3200 MT/s.

Will the Samsung, Micron or Hynix chips on this 2Rx8 module need any firmware updates later?

No firmware updates are required for the DRAM chips; the module runs at 1.2 V with CL22 timings for its service life.

Aj v tomto oddelení

Zákazníci tiež porovnávali

Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.