BFKK
BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
214,99 USD
0.00275801BTC
Skladom
NEMIX RAM
NEMIX RAM DDR5 128GB (2x64GB) 5600MHz CL46 ECC RDIMM Supermicro H13DSG-O-CPU
128 GB DDR5 ECC registered server memory kit in two 64 GB modules at 5600 MHz CL46 for Supermicro H13DSG-O-CPU
- Capacity128GB (2 x 64GB)
- Type288-Pin DDR5 RDIMM
- SpeedDDR5 5600 (PC5 44800)
- CAS LatencyCL46
- Voltage1.10V
- ECCYes
- 128 GB capacity with two 64 GB modules for maximum density
- DDR5 5600 MT/s speed rated at PC5-44800 for high throughput
- CL46 latency at 1.1 V for efficient operation
- ECC and registered design corrects errors and stabilises full loads
- 288-pin RDIMM form factor matches Supermicro H13DSG-O-CPU requirements
Exact-match upgrade for Supermicro H13DSG-O-CPU
This 128 GB kit contains two 64 GB DDR5 RDIMMs rated at 5600 MHz with CL46 latency and 1.1 V operation. The modules are registered and carry ECC so the memory controller sees the correct rank and voltage profile for full-capacity recognition on the target motherboard.
Thermals noise and power draw
Registered ECC RDIMMs run without heat spreaders and draw only 1.1 V at the rated speed. The buffered architecture keeps electrical loading low even when every slot is populated, so the modules add minimal heat and no audible noise inside a server chassis.
Specification that decides fitment
The kit uses 288-pin DDR5 RDIMMs in a 2Rx4 organisation, which is the only form factor and rank the Supermicro H13DSG-O-CPU board accepts. Builders who need UDIMM, SODIMM or a different rank configuration cannot use this memory.
Prednosti
- 128 GB capacity with two 64 GB modules for maximum density
- DDR5 5600 MT/s speed rated at PC5-44800 for high throughput
- CL46 latency at 1.1 V for efficient operation
- ECC and registered design corrects errors and stabilises full loads
- 288-pin RDIMM form factor matches Supermicro H13DSG-O-CPU requirements
Špecifikácie
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM Original Series Server Memory |
| Model | DDR5 ECC RDIMM Registered Server Memory |
| Part Number | MR44800-924K2 |
| Capacity | 128GB (2 x 64GB) |
| Type | 288-Pin DDR5 RDIMM |
| Speed | DDR5 5600 (PC5 44800) |
| CAS Latency | CL46 |
| Voltage | 1.10V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Heat Spreader | No |
| Compatible System | Supermicro |
| Features | DDR5 ECC RDIMM Motherboard Compatible |
| Package Content | 128GB 2X64GB DDR5 5600MHz PC5-44800 2Rx4 1.1V 288-PIN ECC RDIMM KIT |
Otázky k tomuto produktu
How do I install the 288-pin DDR5 RDIMM modules in the Supermicro H13DSG-O-CPU and which slot order does the manual require?
Power down the server, open the chassis, and insert each 64 GB module into the 288-pin DDR5 RDIMM slots following the exact population sequence shown in the Supermicro H13DSG-O-CPU manual; the registered design means every populated slot must match the board's approved order for the 128 GB kit to be recognised at 5600 MHz.
What maintenance or replacement will the 2Rx4 ECC registered RDIMMs need during their service life?
The modules have no moving parts or heat spreaders, so routine maintenance is limited to keeping the server's air filters clean and verifying ECC corrected-error counts in the BMC logs; if a DIMM begins reporting uncorrectable errors the lifetime replacement warranty covers a direct swap of the affected 64 GB stick.
What is the first limit that appears when the 128 GB kit runs sustained workloads at 5600 MHz CL46?
The registered DDR5 5600 CL46 timing at 1.10 V is the primary constraint; under continuous heavy load the memory controller will hold to the rated 5600 MT/s and CL46 latency rather than downclocking, so the bandwidth ceiling defined by PC5-44800 is the first hard limit encountered.
Aj v tomto oddelení
Zákazníci tiež porovnávali
Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.
