BFKK
BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
214,99 USD
0.00278705BTC
Skladom
NEMIX RAM
NEMIX RAM DDR5 6400 96GB (6x16GB) CL52 1.1V ECC RDIMM Supermicro H14DSH
A 96 GB DDR5 registered ECC kit with six 16 GB modules running at 6400 MT/s, CL52 and 1.1 V, validated for the Supermicro H14DSH motherboard
- Capacity96GB (6 x 16GB)
- Type288-Pin DDR5 RDIMM
- SpeedDDR5 6400 (PC5 51200)
- CAS LatencyCL52
- Voltage1.10V
- ECCYes
- 96 GB total capacity across six 16 GB modules
- DDR5-6400 speed with CL52 latency for rated throughput
- Registered ECC architecture prevents silent data corruption
- 1 V operation matches server memory-controller requirements
- 288-pin RDIMM form factor verified for Supermicro H14DSH
96GB DDR5-6400 ECC RDIMM Kit
This 96GB kit contains six 16GB DDR5-6400 Registered ECC RDIMMs built for the Supermicro H14DSH motherboard. Each module runs at 1.1V with CL52 latency and a 1Rx8 organisation. The Registered architecture buffers address and command signals so the memory controller stays stable when every slot is populated.
Suited For And Not Suited For
The kit suits administrators who need the exact capacity, voltage and rank layout the H14DSH firmware expects for full-speed operation. It is not for systems that require unbuffered UDIMMs or SODIMMs, nor for platforms that cannot accept Registered ECC memory. Builders who need a different total capacity or a non-ECC configuration should look elsewhere.
Sustained Load Behaviour
Under continuous workloads the Registered design keeps electrical loading on the controller low, allowing all six slots to run at the rated 6400 MT/s without throttling. ECC corrects single-bit errors on the fly, preventing silent data corruption during long compute runs. The 1.1V operating voltage helps limit heat output when the kit is fully populated for extended periods.
Prednosti
- 96 GB total capacity across six 16 GB modules
- DDR5-6400 speed with CL52 latency for rated throughput
- Registered ECC architecture prevents silent data corruption
- 1 V operation matches server memory-controller requirements
- 288-pin RDIMM form factor verified for Supermicro H14DSH
Špecifikácie
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM Original Series Server Memory |
| Model | DDR5 ECC RDIMM Registered Server Memory |
| Part Number | MR51200-618K6 |
| Capacity | 96GB (6 x 16GB) |
| Type | 288-Pin DDR5 RDIMM |
| Speed | DDR5 6400 (PC5 51200) |
| CAS Latency | CL52 |
| Voltage | 1.10V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 1Rx8 |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Heat Spreader | No |
| Compatible System | Supermicro |
| Features | DDR5 ECC RDIMM Motherboard Compatible |
| Package Content | 96GB 6X16GB DDR5 6400MHz PC5-51200 1Rx8 1.1V 288-PIN ECC RDIMM KIT |
Otázky k tomuto produktu
What motherboard is required for this 6×16 GB DDR5-6400 ECC RDIMM kit to be recognised at full 96 GB capacity?
The kit is spec-matched for the Supermicro H14DSH motherboard; its memory controller expects exactly this 1Rx8 registered ECC configuration at 1.10 V and CL52.
Will these registered ECC modules work if I keep older UDIMMs in the same Supermicro H14DSH board?
No, the H14DSH requires 288-pin RDIMMs; mixing registered and unbuffered DIMMs is not supported and will prevent the system from posting.
How can I confirm the kit is running at its rated DDR5-6400 speed after installation?
Enter the BIOS or use a hardware-info utility and verify the memory frequency reads 6400 MT/s with CL52 timings at 1.10 V across all six slots.
Aj v tomto oddelení
Zákazníci tiež porovnávali
Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.
