Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.

Sledované položky Prihlásiť sa
Two green circuit boards with gold contacts and black memory chips, no heat spreaders

NEMIX RAM

NEMIX RAM MR51200-4828K2 96GB (2x48GB) DDR5 6400 CL52 ECC RDIMM memory upgrade

SKU CH-DCSV-HJSX3

A 96 GB DDR5 ECC registered DIMM kit built for Supermicro H13SRA motherboards, delivering 6400 MT/s at CL52 and 1.1 V in a 2×48 GB configuration

  • Capacity96GB (2 x 48GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 6400 (PC5 51200)
  • CAS LatencyCL52
  • Voltage1.10V
  • ECCYes

Size 96GB 2X48GB

Zobraziť ďalších 6 konfigurácií
  • 96GB total capacity from a matched 2×48GB kit for maximum supported density
  • DDR5-6400 (PC5-51200) speed with CL52 latency runs at rated frequency on compatible boards
  • Registered ECC architecture with 2Rx8 organisation offloads the controller and corrects single-bit errors
  • 1V operating voltage and 288-pin RDIMM form factor match Supermicro H13SRA-F/TF requirements exactly
  • Built with major OEM Samsung, Micron or Hynix chips for enterprise-grade reliability

Exact-match DDR5 kit for Supermicro H13SRA

This 96GB kit delivers two 48GB DDR5 6400 CL52 ECC RDIMM modules built to the exact rank, voltage and timing the Supermicro H13SRA-F and H13SRA-TF memory controller expects. The 2Rx8 registered design with 1.10V operation ensures full capacity recognition at rated speed without manual tuning. It is not for systems that require UDIMM or SODIMM form factors, or for boards limited to lower DDR5 data rates.

Straightforward RDIMM installation

Align the 288-pin modules with the keyed slots and press until the retention clips engage; registered DIMMs seat with the same force as standard server memory. The most common issue is populating slots in an order the motherboard firmware does not support, which can leave capacity unrecognised or force a reduced speed. Always follow the board manual's population sequence and verify firmware is current before powering on.

Verify motherboard rules before ordering

Confirm your Supermicro H13SRA-F or H13SRA-TF revision supports 48GB per slot and the total 96GB capacity with 2Rx8 registered ECC modules. Check the approved DIMM population order, maximum supported speed with two DIMMs installed, and any BIOS version requirements listed in the system documentation. This kit is not suitable for platforms that only accept unbuffered DDR5 or that cap registered memory at lower densities.

Prednosti

  • 96GB total capacity from a matched 2×48GB kit for maximum supported density
  • DDR5-6400 (PC5-51200) speed with CL52 latency runs at rated frequency on compatible boards
  • Registered ECC architecture with 2Rx8 organisation offloads the controller and corrects single-bit errors
  • 1V operating voltage and 288-pin RDIMM form factor match Supermicro H13SRA-F/TF requirements exactly
  • Built with major OEM Samsung, Micron or Hynix chips for enterprise-grade reliability

Špecifikácie

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR51200-4828K2
Capacity96GB (2 x 48GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 6400 (PC5 51200)
CAS LatencyCL52
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content96GB 2X48GB DDR5 6400MHz PC5-51200 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Ďalšie verzie tohto modelu

Ďalších 5 v tomto rade

Rovnaký rad, iná pamäť, chladič alebo frekvencia — porovnajte pred rozhodnutím.

Otázky k tomuto produktu

How can I confirm the 96GB kit is running at DDR5 6400 with CL52 after installation?

Enter the BIOS or UEFI on the Supermicro H13SRA-F or H13SRA-TF motherboard and verify the memory speed shows 6400 MT/s, CAS latency 52, voltage 1.10 V, and total capacity 96 GB across both 48 GB modules.

What comes in the box and is anything else required to install the MR51200-4828K2 kit?

The package contains two 48 GB DDR5 288-pin ECC Registered RDIMM modules. No additional parts are needed; the motherboard provides the slots and power for the 1.10 V modules.

Which capacity version should I choose for a Supermicro H13SRA-TF that supports up to 96 GB per channel?

This 96 GB kit (2 x 48 GB, 2Rx8) matches the board's DDR5 6400 PC5-51200 registered ECC specification and fills two DIMM slots for full rated performance.

Aj v tomto oddelení

Zákazníci tiež porovnávali

Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.